Wyoming Air Brakes CDL Practice Test

This is a free 20-question practice test for the Air Brakes portion of the Wyoming Commercial Driver's License knowledge exam. Questions are pulled from a pool of 71 drawn from the AAMVA CDL Manual, which is the source document the Wyoming Department of Transportation Driver Services uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Wyoming.

Question 1 of 20

The parts of an air-brake system include:

Air compressor, governor, air storage tanks, foot valve, and brake chambers
Master cylinder, brake fluid, and calipers
Hydraulic pump, lines, and disc rotors
Vacuum booster and reservoir

Correct. Air-brake systems use a compressor, governor, storage tanks, foot valve, and brake chambers — distinct from hydraulic systems used in cars.

Question 2 of 20

In a dual air-brake system, the time required for air pressure to build from 85 to 100 psi should be no more than:

15 seconds
30 seconds
45 seconds
120 seconds

Correct. In dual air-brake systems, air should build from 85 to 100 psi within 45 seconds at engine governed RPM.

Question 3 of 20

The service brakes are operated by:

The yellow parking-brake knob
The red trailer-supply knob
The foot valve (brake pedal)
The hand throttle

Correct. Service brakes are applied by the foot valve / brake pedal. The yellow and red knobs control parking and trailer-supply functions.

Question 4 of 20

In a dual air-brake system, you should let the air pressure build to at least what level before driving?

60 psi
80 psi
100 psi
125 psi

Correct. Wait until the system pressure is at least 100 psi before driving in a dual air-brake system.

Question 5 of 20

When should you NOT use the parking brakes?

When the vehicle is parked
When the brakes are very hot, such as after a long downgrade — they could damage if applied
At any time
When the engine is off

Correct. Hot brakes can be damaged by the spring brakes contracting against hot drums. Let the brakes cool before parking.

Question 6 of 20

When the spring brakes apply automatically as air pressure drops, this typically happens between:

100 and 120 psi
60 and 80 psi
20 and 45 psi
5 and 10 psi

Correct. Spring brakes will fully apply somewhere between 20 and 45 psi as system pressure drops, depending on the vehicle.

Question 7 of 20

The governor controls:

Engine RPM
When the air compressor pumps air into the air storage tanks
Brake-pedal travel
Trailer hand-valve operation

Correct. The governor cycles the compressor: it cuts the compressor in around 100 psi and cuts it out around 125 psi.

Question 8 of 20

In an emergency stop on a non-ABS vehicle, you should:

Apply the brakes lightly
Use stab braking — full brake until wheels lock, release, repeat
Pump the brakes rapidly
Apply only the trailer hand valve

Correct. Stab braking applies brakes hard until the wheels lock, then releases when you feel skid — this slows the vehicle while keeping it straight.

Question 9 of 20

Air-brake disc brakes use:

Air to apply force to a clamp on a rotating disc, instead of a drum
Hydraulic fluid
A separate fuel system
Spring force only

Correct. Disc brakes use a brake chamber and slack adjuster like S-cam drum brakes, but the force closes a caliper on a rotor instead of forcing shoes against a drum.

Question 10 of 20

You hear a steady "ssss" sound while parked with the engine off. This is most likely:

Normal venting
An air leak that needs immediate attention
The compressor running
Trailer brakes releasing

Correct. A steady hiss with the engine off indicates an air leak — find and repair before driving.

Question 11 of 20

The parking-brake control:

Is a yellow diamond-shaped knob
Is a red round knob
Is a green knob
Does not exist on modern trucks

Correct. The parking-brake control is a yellow diamond-shaped knob, distinct from the red round trailer-supply knob.

Question 12 of 20

If you must drive a vehicle with manual front-wheel-brake limiting valve, you should keep it in the "normal" position:

Always
Only on slick roads
In the slippery position only
Only when empty

Correct. Keep the front-wheel limiting valve in the "normal" position. Modern trucks rarely have this valve, but if equipped, leaving it in "slippery" reduces front braking and lengthens stopping distance.

Question 13 of 20

If a trailer breaks away, the emergency brakes on the trailer will be applied because:

The driver pulled the parking brake
The air supply to the trailer is interrupted, releasing the spring brakes on the trailer
The trailer wiring shuts down
The trailer ABS engages

Correct. When the air line breaks (or is disconnected), trailer air pressure drops and the trailer spring brakes apply, stopping the trailer.

Question 14 of 20

Air storage tanks are used to:

Carry coolant
Hold compressed air for use by the brakes
Store fuel
House the alternator

Correct. Air storage (or "supply") tanks hold compressed air ready for brake application. Trucks have multiple tanks for redundancy.

Question 15 of 20

Air tanks must be drained because:

They get heavy
Compressor oil and water can collect inside, contaminating the brake system
They expire
It is required after every trip

Correct. Water and compressor oil collect at the bottom of air tanks. They must be drained to keep the system clean and prevent winter freeze-ups.

Question 16 of 20

When should you use the trailer hand valve to slow the rig?

Whenever you want trailer-only braking
Never; using the trailer hand valve alone can cause a trailer skid
Always when going downhill
Only on dry pavement

Correct. Using the trailer hand valve alone applies brakes only at the trailer wheels and can cause the trailer to lock up and skid. Always use the foot valve to brake.

Question 17 of 20

Continuous use of the brakes on a long downgrade can cause:

Improved braking
Brake fade — loss of braking effectiveness due to overheating
No effect
Faster wear of the air compressor

Correct. Holding the brakes overheats them and causes brake fade — drums expand and brake compounds lose effectiveness, reducing braking force.

Question 18 of 20

The supply pressure gauges show:

The brake-pedal pressure
The pressure in the air storage tanks
The amount of air being used by the brakes
The trailer brake pressure only

Correct. The supply (primary and secondary) pressure gauges show air pressure available for braking — a critical reading before driving and during operation.

Question 19 of 20

Slack adjusters need to be checked because:

They wear and require adjustment to maintain braking force
They never need attention
They are decorative
They affect only the parking brake

Correct. Slack adjusters control how far the pushrod must travel to apply the brake. Out-of-adjustment slack adjusters are the leading mechanical cause of out-of-service violations.

Question 20 of 20

Pre-trip air-brake check (Step 1) is to:

Test the parking brake
Test the air leakage rate
Time the air-pressure build-up
Check the slack adjusters

Correct. In the seven-step air-brake check the first step is testing the parking brake — release service brakes, set parking brake, gently try to move the vehicle in low gear.

About the Wyoming Air Brakes exam

States typically administer 25 Air Brakes questions and require 80% to pass. Questions cover air-brake system parts, dual systems, supply pressure, brake-system warning, slack adjusters, the parking brake, the spring brake, the pre-trip air-system check, and the proper way to perform a leakage-rate test.

The Wyoming Department of Transportation Driver Services follows the federal CDL standards established by FMCSA. To earn the Air Brakes credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Air Brakes question bank or browse all Wyoming CDL practice tests.