Washington Doubles/Triples CDL Practice Test

This is a free 20-question practice test for the Doubles/Triples portion of the Washington Commercial Driver's License knowledge exam. Questions are pulled from a pool of 50 drawn from the AAMVA CDL Manual, which is the source document the Washington State Department of Licensing uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Washington.

Question 1 of 20

The "T" endorsement is required to:

Drive any commercial vehicle
Pull two or more trailers
Drive a bus
Haul hazmat

Correct. The T endorsement is required to pull more than one trailer (doubles or triples).

Question 2 of 20

When pulling a heavy lead trailer and a light second trailer, the rig:

Will be more stable than the reverse
Is more likely to roll the rear trailer
Is illegal
Drives the same as either order

Correct. Heaviest in front, lightest in rear. Heavy at the rear amplifies crack-the-whip and rollover risk.

Question 3 of 20

When coupling the second trailer to the converter dolly:

Position the dolly in front of the second trailer, lower trailer landing gear if necessary, lock the dolly to the lead trailer's pintle hook with safety chains, then back the second trailer onto the fifth wheel
Just push them together
Use the trailer hand valve
Drive past it fast

Correct. Position dolly, secure to lead-trailer pintle, then back second trailer over the fifth wheel and lock as a normal coupling.

Question 4 of 20

Doubles and triples should not be driven:

On slippery roads at normal speed
On dry, straight highways
In any conditions
Only at low speed

Correct. On slippery roads, multi-trailer rigs lose stability quickly. Reduce speed substantially and increase following distance.

Question 5 of 20

In a multi-trailer combination, the most violent movement during evasive maneuvers happens at:

The tractor
The first trailer
The last trailer
The cab

Correct. Rearward amplification (crack-the-whip effect) is greatest at the rear-most trailer. The last trailer in a triple can be thrown sideways with much greater force than the tractor.

Question 6 of 20

A "set of triples" typically refers to:

One tractor pulling three trailers
Three trailers without a tractor
Three tractors and one trailer
Three tractors only

Correct. A set of triples is one tractor pulling three trailers — usually allowed only on specific designated routes.

Question 7 of 20

Safety chains on a converter dolly are required to:

Prevent the dolly from disconnecting if the pintle hook fails
Decorate the rig
Bind cargo
Add weight

Correct. Safety chains catch the dolly if the pintle hook releases or fails — preventing the trailer behind from breaking loose.

Question 8 of 20

A pintle hook is:

The hitch on the rear of a trailer used to tow another trailer or dolly
The kingpin
The fifth wheel
A type of placard

Correct. The pintle hook is the strong rear-mounted hitch that grips the dolly's lunette eye, allowing one trailer to tow another behind it.

Question 9 of 20

Crosswinds are particularly hazardous for:

Empty doubles and triples
Loaded singles
Backing
Slow speeds

Correct. Empty trailers in a multi-trailer rig present a large flat surface to crosswinds — a strong gust can blow the rear trailer over.

Question 10 of 20

Triples are restricted in many states. You should:

Drive triples anywhere
Verify state-by-state legality before crossing into a state
Use a special placard
Avoid driving in cities

Correct. Many states restrict triples to specific routes (turnpikes, designated corridors). Verify legality and route before crossing into a state.

Question 11 of 20

When pulling doubles in a tunnel:

Stay alert; clearance and turning radius can be tight
Drive faster
Stop in the middle
Honk continuously

Correct. Tunnel clearance can be tight for long doubles — watch overhead and side clearance, and respect any vehicle-class restrictions.

Question 12 of 20

When inspecting a doubles or triples rig, you should additionally check:

Each pintle hook, each set of safety chains, each converter dolly, each trailer's lights, brake chamber connections, glad-hands, and shut-off valves
Only the lead trailer
Only the tractor
Only the cargo

Correct. Every connection point and every trailer needs inspection — pintle hooks, chains, dollies, lights, brake lines, glad-hands, and air-supply valves.

Question 13 of 20

The driver of a doubles rig should:

Make slow, gradual steering and braking inputs
Drive aggressively
Use only the trailer brake
Honk frequently

Correct. Smooth, gradual inputs are critical. Avoid abrupt steering and abrupt braking.

Question 14 of 20

When pulling a single trailer and trying to figure out if you should add a doubles endorsement:

You only need T if you actually pull more than one trailer
T is required for any commercial driving
T is required only for tankers
T is required for any class A driver

Correct. The T endorsement is required only when you actually operate doubles or triples. Single-trailer operations do not require it.

Question 15 of 20

When pulling triples, you should:

Make abrupt lane changes
Drive in the right lane and avoid abrupt steering
Drive in the left lane
Drive at top speed

Correct. Stay right, plan lane changes well in advance, signal early, and avoid abrupt steering. Triples crack-the-whip violently.

Question 16 of 20

A tractor pulling doubles cannot brake as quickly as a tractor pulling a single trailer because:

Doubles are heavier and brake response is delayed in longer air lines
Doubles are lighter
Brakes are bigger
Tractors brake better with doubles

Correct. Greater weight and longer air lines mean longer braking distance. Plan stopping distance with extra margin.

Question 17 of 20

A converter-dolly fifth wheel must be:

Properly lubricated and have correctly functioning locking jaws
Painted
Wide
Empty

Correct. Inspect for proper lubrication, no excessive wear, and confirm the locking jaws operate correctly. The dolly fifth wheel is just as critical as the tractor's.

Question 18 of 20

When testing the brakes on a doubles rig:

Do all the standard checks plus verify air pressure builds at the rear trailer and that brakes apply at all wheels
Only test the tractor
Only test the lead trailer
Skip the test

Correct. Test the entire rig: build-up time, leakage, low-pressure warning, parking brake, and confirm rear-trailer brake function.

Question 19 of 20

During a pre-trip on doubles, the trailer-supply line:

Should be open from tractor to rear-most trailer
Should be open at the front but closed at the rear-most trailer
Should be closed everywhere
Should always be disconnected

Correct. The supply line carries air from tractor through every trailer; verify open valves at every coupled connection and a closed valve at the rear of the rear-most trailer.

Question 20 of 20

When adjusting the order of trailers in a multi-trailer rig:

Place the heaviest immediately behind the tractor and progressively lighter to the rear
Place the heaviest at the rear
Order does not matter
Order is alphabetical

Correct. Heaviest first, lightest last. This minimizes rearward amplification and rollover risk in the rear trailers.

About the Washington Doubles/Triples exam

Most states administer 20 Doubles/Triples questions and require 80% to pass. The exam emphasizes coupling and uncoupling the converter dolly, rearward amplification (the "crack-the-whip" effect), and the unique inspection and handling demands of multi-trailer rigs.

The Washington State Department of Licensing follows the federal CDL standards established by FMCSA. To earn the Doubles/Triples credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Doubles/Triples question bank or browse all Washington CDL practice tests.