Virginia Combination Vehicles CDL Practice Test
This is a free 20-question practice test for the Combination Vehicles portion of the Virginia Commercial Driver's License knowledge exam. Questions are pulled from a pool of 55 drawn from the AAMVA CDL Manual, which is the source document the Virginia Department of Motor Vehicles uses to write its actual exam.
How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Virginia.
Question 1 of 20
Before uncoupling, you should:
Correct. Proper sequence: park level, lower landing gear to support the trailer, disconnect lines, release jaws, then pull forward slowly. Skipping any step risks dropping the trailer.
Question 2 of 20
To make a trailer go where you want when backing, the steering wheel should:
Correct. Backing is opposite-direction steering: to swing the trailer right, turn the wheel left first, then correct as the trailer follows.
Question 3 of 20
The trailer hand valve should be used:
Correct. Use the trailer hand valve only for testing trailer brakes. Using it to slow the rig can cause the trailer to skid or jackknife.
Question 4 of 20
Trailer rollover is more likely when:
Correct. High cargo and uneven side-loading raise the center of gravity, increasing rollover risk on curves and ramps.
Question 5 of 20
Length and weight increase what about a combination vehicle?
Correct. Longer, heavier rigs need more stopping distance, swing wider in turns, have larger blind spots, and require more time and space to change lanes.
Question 6 of 20
A "trailer skid" happens when:
Correct. When trailer wheels lose traction (often from over-application of trailer brakes alone), the trailer can slide sideways — a trailer skid or trailer swing.
Question 7 of 20
During a pre-trip inspection, you should also check that the cargo:
Correct. Cargo securement, weight balance, and size compliance are all driver responsibilities — check before each trip.
Question 8 of 20
A combination vehicle on slippery roads should be driven:
Correct. Reduce speed by at least one third on wet roads and one half on snow; double following distance on slick surfaces.
Question 9 of 20
Auxiliary equipment (refrigeration, hydraulic lift gates) on the trailer:
Correct. Reefer units, lift gates, and other auxiliary equipment add weight and may shift CG. Inspect securement and check operation in pre-trip.
Question 10 of 20
A sliding fifth wheel allows you to:
Correct. Sliding fifth wheels move forward to put more weight on drive axles or aft to reduce drive-axle weight, helping comply with axle-weight limits.
Question 11 of 20
The air lines connecting the tractor and trailer are:
Correct. The red glad-hand carries emergency/supply air; the blue glad-hand carries service air. They cross to keep matched colors when coupling.
Question 12 of 20
A combination vehicle requires more time to stop than a single vehicle because:
Correct. Greater weight + brake-lag in long air lines = longer stopping distance. Plan ahead.
Question 13 of 20
A safe practice when arriving at a destination is to:
Correct. Slow approach with mirror checks gives time to identify clearance issues and pedestrians.
Question 14 of 20
Combination vehicles are usually:
Correct. Combination vehicles (tractor-trailer rigs) are heavier, longer, and articulate at the fifth wheel — all making them more demanding than single-unit trucks.
Question 15 of 20
When making a turn, you should signal:
Correct. Signal early enough that other drivers see and process the signal — generally at least 100 feet before in town, longer at highway speeds.
Question 16 of 20
When uncoupling, you should lower the landing gear:
Correct. Lower the landing gear and snug it against the ground before releasing the fifth-wheel jaws so the trailer doesn't drop when you pull away.
Question 17 of 20
Trailer wheels off-track:
Correct. Trailer wheels follow a tighter path than tractor wheels through a turn — off-tracking. Plan turns to keep trailer tires on the pavement and clear of curbs.
Question 18 of 20
When you check the fifth wheel during pre-trip, you look for:
Correct. Check mount, condition, gap, jaw engagement around kingpin shank (not the head), and release-arm lock position. Lubrication should be present but not excessive.
Question 19 of 20
When you are backing a trailer to the right, you should turn the steering wheel:
Correct. When backing, the trailer goes opposite to the way you initially turn the steering wheel. To make the trailer go right (passenger side), start by turning the wheel left.
Question 20 of 20
A jackknife happens when:
Correct. Jackknife is when the drive wheels skid and the trailer continues forward, causing the tractor to pivot — the rig folds at the fifth wheel like a closing knife.
About the Virginia Combination Vehicles exam
Most states administer 20 Combination Vehicles questions and require 80% to pass. The exam emphasizes the unique handling of articulated vehicles: how trailers track behind the tractor, how to prevent rollover, how to manage rearward amplification with multi-trailer combinations, and the correct sequence to couple and uncouple.
The Virginia Department of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Combination Vehicles credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.
Want more practice? Try the full Combination Vehicles question bank or browse all Virginia CDL practice tests.