Utah Air Brakes CDL Practice Test

This is a free 20-question practice test for the Air Brakes portion of the Utah Commercial Driver's License knowledge exam. Questions are pulled from a pool of 71 drawn from the AAMVA CDL Manual, which is the source document the Utah Driver License Division uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Utah.

Question 1 of 20

In a dual air-brake system, you should let the air pressure build to at least what level before driving?

60 psi
80 psi
100 psi
125 psi

Correct. Wait until the system pressure is at least 100 psi before driving in a dual air-brake system.

Question 2 of 20

A low-air-pressure warning device must come on at or before:

20 psi
40 psi
60 psi
80 psi

Correct. A federal-mandated low-air-pressure warning (light, buzzer, or wig-wag) must activate at or before 60 psi.

Question 3 of 20

The S-cam:

Is a type of fuel pump
Forces the brake shoes against the drum to provide braking action
Adjusts the slack adjuster
Is the parking-brake control

Correct. When the foot valve is pressed, air pushes the brake-chamber pushrod, which moves the slack adjuster, which rotates the S-cam shaft, forcing the shoes against the drum.

Question 4 of 20

Which of these is the safest speed for descending a long, steep grade?

The posted speed limit
A speed slow enough that the brakes can hold without overheating, typically below the speed limit
Whatever speed you went up the hill
Maximum gear-down speed

Correct. Choose a speed and gear that lets the brakes work intermittently without continuous pressure. Posted truck-grade signs help.

Question 5 of 20

When brake drums or shoes get very hot, you should:

Park immediately
Continue driving
Pull over and let them cool, but do not apply the parking brake until they have cooled
Throw water on them

Correct. Park where you can let the brakes cool. Do not apply the parking (spring) brake on overheated brakes — it can damage them or cause warpage.

Question 6 of 20

The governor controls:

Engine RPM
When the air compressor pumps air into the air storage tanks
Brake-pedal travel
Trailer hand-valve operation

Correct. The governor cycles the compressor: it cuts the compressor in around 100 psi and cuts it out around 125 psi.

Question 7 of 20

Modulating valves on the trailer:

Don't exist
Apply increasing brake pressure as you push the foot valve harder
Are emergency-only
Open the parking brake

Correct. The trailer service brakes are modulated — pressing harder on the foot valve produces more brake-chamber pressure at the trailer.

Question 8 of 20

For a single vehicle (not a combination) with engine off and brakes released, the maximum allowable air-loss rate is:

1 psi/min
2 psi/min
3 psi/min
4 psi/min

Correct. A single vehicle is allowed no more than 2 psi/min of air loss with engine off and brakes released.

Question 9 of 20

If a trailer breaks away, the emergency brakes on the trailer will be applied because:

The driver pulled the parking brake
The air supply to the trailer is interrupted, releasing the spring brakes on the trailer
The trailer wiring shuts down
The trailer ABS engages

Correct. When the air line breaks (or is disconnected), trailer air pressure drops and the trailer spring brakes apply, stopping the trailer.

Question 10 of 20

The spring brakes:

Are held off by air pressure and apply automatically when pressure drops
Are activated only by the foot valve
Are activated only by the trailer hand valve
Are not used in modern trucks

Correct. Spring brakes use heavy springs that apply the brake when air pressure is released or drops below 20-45 psi — they serve as both parking and emergency brake.

Question 11 of 20

Slack adjusters need to be checked because:

They wear and require adjustment to maintain braking force
They never need attention
They are decorative
They affect only the parking brake

Correct. Slack adjusters control how far the pushrod must travel to apply the brake. Out-of-adjustment slack adjusters are the leading mechanical cause of out-of-service violations.

Question 12 of 20

Total stopping distance with air brakes equals:

Perception distance + reaction distance + brake-lag distance + effective braking distance
Reaction distance only
Brake-lag distance only
Perception distance + braking distance

Correct. Add brake-lag distance to the standard perception + reaction + braking distance for any vehicle with air brakes.

Question 13 of 20

You should never leave the vehicle unattended without:

Locking the doors
Applying the parking brakes and chocking the wheels if necessary
Turning off the radio
Removing the key

Correct. Set the parking brake. On grades or where unintended movement could occur, chock the wheels in addition.

Question 14 of 20

Pre-trip air-brake check (Step 1) is to:

Test the parking brake
Test the air leakage rate
Time the air-pressure build-up
Check the slack adjusters

Correct. In the seven-step air-brake check the first step is testing the parking brake — release service brakes, set parking brake, gently try to move the vehicle in low gear.

Question 15 of 20

When you make a normal stop with air brakes, you should:

Push the brake pedal down hard
Apply firm steady pressure to slow you smoothly
Pump the brakes
Use only the trailer brake

Correct. For normal stops, apply steady firm pressure on the foot valve and adjust to maintain a smooth stop.

Question 16 of 20

The trailer air-supply control:

Is a yellow diamond knob
Is a red eight-sided (octagonal) knob
Is a green knob
Is the same knob as the parking brake

Correct. The trailer air-supply (tractor protection) is a red eight-sided knob. Push in to supply air to the trailer; pull out to shut off air.

Question 17 of 20

When should you NOT use the parking brakes?

When the vehicle is parked
When the brakes are very hot, such as after a long downgrade — they could damage if applied
At any time
When the engine is off

Correct. Hot brakes can be damaged by the spring brakes contracting against hot drums. Let the brakes cool before parking.

Question 18 of 20

Air-brake disc brakes use:

Air to apply force to a clamp on a rotating disc, instead of a drum
Hydraulic fluid
A separate fuel system
Spring force only

Correct. Disc brakes use a brake chamber and slack adjuster like S-cam drum brakes, but the force closes a caliper on a rotor instead of forcing shoes against a drum.

Question 19 of 20

When checking the brakes on a downgrade, you should:

Use the air-pressure gauge to monitor brake-system pressure for excessive use
Pump the pedal
Drive faster
Ignore the gauge

Correct. Watch the air-pressure gauge. If pressure drops faster than the compressor can recover, brakes are being used too aggressively for the gear selection.

Question 20 of 20

Manual slack adjusters must be adjusted:

Only by a mechanic at the dealership
By the driver, when needed, following manufacturer specifications
Never
Only at the time of vehicle inspection

Correct. Drivers may adjust manual slack adjusters in compliance with manufacturer specifications. Automatic slack adjusters are now standard but still require periodic checking.

About the Utah Air Brakes exam

States typically administer 25 Air Brakes questions and require 80% to pass. Questions cover air-brake system parts, dual systems, supply pressure, brake-system warning, slack adjusters, the parking brake, the spring brake, the pre-trip air-system check, and the proper way to perform a leakage-rate test.

The Utah Driver License Division follows the federal CDL standards established by FMCSA. To earn the Air Brakes credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Air Brakes question bank or browse all Utah CDL practice tests.