Texas Air Brakes CDL Practice Test

This is a free 20-question practice test for the Air Brakes portion of the Texas Commercial Driver's License knowledge exam. Questions are pulled from a pool of 71 drawn from the AAMVA CDL Manual, which is the source document the Texas Department of Public Safety Driver License Division uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Texas.

Question 1 of 20

The supply pressure gauges show:

The brake-pedal pressure
The pressure in the air storage tanks
The amount of air being used by the brakes
The trailer brake pressure only

Correct. The supply (primary and secondary) pressure gauges show air pressure available for braking — a critical reading before driving and during operation.

Question 2 of 20

Air storage tanks are used to:

Carry coolant
Hold compressed air for use by the brakes
Store fuel
House the alternator

Correct. Air storage (or "supply") tanks hold compressed air ready for brake application. Trucks have multiple tanks for redundancy.

Question 3 of 20

Air tanks must be drained because:

They get heavy
Compressor oil and water can collect inside, contaminating the brake system
They expire
It is required after every trip

Correct. Water and compressor oil collect at the bottom of air tanks. They must be drained to keep the system clean and prevent winter freeze-ups.

Question 4 of 20

The governor controls:

Engine RPM
When the air compressor pumps air into the air storage tanks
Brake-pedal travel
Trailer hand-valve operation

Correct. The governor cycles the compressor: it cuts the compressor in around 100 psi and cuts it out around 125 psi.

Question 5 of 20

The parts of an air-brake system include:

Air compressor, governor, air storage tanks, foot valve, and brake chambers
Master cylinder, brake fluid, and calipers
Hydraulic pump, lines, and disc rotors
Vacuum booster and reservoir

Correct. Air-brake systems use a compressor, governor, storage tanks, foot valve, and brake chambers — distinct from hydraulic systems used in cars.

Question 6 of 20

When you make a normal stop with air brakes, you should:

Push the brake pedal down hard
Apply firm steady pressure to slow you smoothly
Pump the brakes
Use only the trailer brake

Correct. For normal stops, apply steady firm pressure on the foot valve and adjust to maintain a smooth stop.

Question 7 of 20

Air brakes take longer to work than hydraulic brakes because:

Air takes longer to flow than fluid
Air-brake lines are longer than hydraulic lines and have more components
Drivers wait longer to brake
Air brakes are simpler

Correct. Brake-lag in air systems comes from the time air takes to travel through lines and reach all the brake chambers — typically 0.4 seconds added to perception/reaction time.

Question 8 of 20

In a dual air-brake system, the time required for air pressure to build from 85 to 100 psi should be no more than:

15 seconds
30 seconds
45 seconds
120 seconds

Correct. In dual air-brake systems, air should build from 85 to 100 psi within 45 seconds at engine governed RPM.

Question 9 of 20

Modern trucks have ABS that is required on:

Tractors built after March 1, 1998 and trailers built after March 1, 1998
All trucks
Only school buses
Only doubles

Correct. Federal rule: tractors built after March 1, 1997, and trailers and single-unit air-braked vehicles after March 1, 1998, must have ABS.

Question 10 of 20

Slack adjusters need to be checked because:

They wear and require adjustment to maintain braking force
They never need attention
They are decorative
They affect only the parking brake

Correct. Slack adjusters control how far the pushrod must travel to apply the brake. Out-of-adjustment slack adjusters are the leading mechanical cause of out-of-service violations.

Question 11 of 20

On a vehicle with ABS, in an emergency stop you should:

Pump the brakes
Apply the brakes the way you always would and steer where you need to go
Apply the parking brake
Coast

Correct. ABS lets you brake hard and continue steering. Brake firmly and avoid pumping — pumping defeats the system.

Question 12 of 20

The spring brakes:

Are held off by air pressure and apply automatically when pressure drops
Are activated only by the foot valve
Are activated only by the trailer hand valve
Are not used in modern trucks

Correct. Spring brakes use heavy springs that apply the brake when air pressure is released or drops below 20-45 psi — they serve as both parking and emergency brake.

Question 13 of 20

Manual slack adjusters must be adjusted:

Only by a mechanic at the dealership
By the driver, when needed, following manufacturer specifications
Never
Only at the time of vehicle inspection

Correct. Drivers may adjust manual slack adjusters in compliance with manufacturer specifications. Automatic slack adjusters are now standard but still require periodic checking.

Question 14 of 20

The trailer air-supply control:

Is a yellow diamond knob
Is a red eight-sided (octagonal) knob
Is a green knob
Is the same knob as the parking brake

Correct. The trailer air-supply (tractor protection) is a red eight-sided knob. Push in to supply air to the trailer; pull out to shut off air.

Question 15 of 20

When should you NOT use the parking brakes?

When the vehicle is parked
When the brakes are very hot, such as after a long downgrade — they could damage if applied
At any time
When the engine is off

Correct. Hot brakes can be damaged by the spring brakes contracting against hot drums. Let the brakes cool before parking.

Question 16 of 20

You are driving a fully loaded combination vehicle on a steep downgrade. Your safe speed is 30 mph and you have already shifted to a lower gear. The proper braking technique is to:

Hold the brakes lightly the whole way
Apply firmly to slow to 25 mph (5 mph below safe speed), release, and let speed build back to 30, then repeat
Stay at 30 mph
Apply only the trailer brake

Correct. The "snub-and-release" method: brake firmly to drop 5 mph below safe speed, release until safe speed returns, repeat. Holding the brakes overheats them.

Question 17 of 20

Pre-trip air-brake check (Step 1) is to:

Test the parking brake
Test the air leakage rate
Time the air-pressure build-up
Check the slack adjusters

Correct. In the seven-step air-brake check the first step is testing the parking brake — release service brakes, set parking brake, gently try to move the vehicle in low gear.

Question 18 of 20

A long downgrade requires:

Riding the brakes the whole way
Selecting a low gear before starting down and using intermittent firm brake applications
Coasting in neutral
Using the engine brake only

Correct. Pick a low gear before starting down. Use the brakes in firm, intermittent applications: brake to 5 mph below safe speed, release, repeat.

Question 19 of 20

For a single vehicle (not a combination) with engine off and brakes released, the maximum allowable air-loss rate is:

1 psi/min
2 psi/min
3 psi/min
4 psi/min

Correct. A single vehicle is allowed no more than 2 psi/min of air loss with engine off and brakes released.

Question 20 of 20

In a dual air-brake system, you should let the air pressure build to at least what level before driving?

60 psi
80 psi
100 psi
125 psi

Correct. Wait until the system pressure is at least 100 psi before driving in a dual air-brake system.

About the Texas Air Brakes exam

States typically administer 25 Air Brakes questions and require 80% to pass. Questions cover air-brake system parts, dual systems, supply pressure, brake-system warning, slack adjusters, the parking brake, the spring brake, the pre-trip air-system check, and the proper way to perform a leakage-rate test.

The Texas Department of Public Safety Driver License Division follows the federal CDL standards established by FMCSA. To earn the Air Brakes credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Air Brakes question bank or browse all Texas CDL practice tests.