South Carolina Doubles/Triples CDL Practice Test

This is a free 20-question practice test for the Doubles/Triples portion of the South Carolina Commercial Driver's License knowledge exam. Questions are pulled from a pool of 50 drawn from the AAMVA CDL Manual, which is the source document the South Carolina Department of Motor Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in South Carolina.

Question 1 of 20

Drivers should always couple the heaviest trailer:

Behind the tractor (in the front position)
At the rear
In the middle
It does not matter

Correct. Heaviest trailer goes directly behind the tractor; lightest goes at the rear. This minimizes rearward amplification and rollover risk.

Question 2 of 20

You should never:

Quickly steer to the left while pulling triples
Drive at the speed limit
Use turn signals
Stop at intersections

Correct. Sudden steering with triples can cause the rear trailer to roll. Avoid abrupt steering and plan lane changes far in advance.

Question 3 of 20

A converter dolly is:

A small hand truck
A set of axles with a fifth wheel that converts a semi-trailer into a full trailer for use in doubles/triples
A trailer-loading device
A type of brake

Correct. A converter dolly has a small frame, axle(s), and a fifth wheel mounted on top — it transforms a semi-trailer into a full trailer behind another trailer.

Question 4 of 20

When inspecting a doubles or triples rig, you should additionally check:

Each pintle hook, each set of safety chains, each converter dolly, each trailer's lights, brake chamber connections, glad-hands, and shut-off valves
Only the lead trailer
Only the tractor
Only the cargo

Correct. Every connection point and every trailer needs inspection — pintle hooks, chains, dollies, lights, brake lines, glad-hands, and air-supply valves.

Question 5 of 20

Glad-hand shut-off valves at the rear of trailers (for connecting to a following trailer) must be:

Open at the rear of the rear-most trailer
Open at the rear of any trailer that has another trailer behind it; closed at the rear of the last trailer
Always closed
Always open

Correct. Open the shut-off valves where the next trailer is connected; close them at the rear of the last trailer to prevent air loss.

Question 6 of 20

An empty rear trailer on a multi-trailer rig:

Is more likely to roll over in evasive steering than a loaded one
Is always stable
Cannot roll over
Has no effect

Correct. Lighter trailer = more vulnerable to crack-the-whip and crosswinds. Empty rear trailers in multi-trailer rigs roll easily.

Question 7 of 20

Before connecting a converter dolly, you should:

Inspect tires, brakes, fifth-wheel jaws, and overall condition
Skip inspection
Only check the tires
Only check the lights

Correct. Pre-trip the dolly: tires, brake adjustment, fifth-wheel jaws (open and clean), pintle hook, electrical receptacle, lights.

Question 8 of 20

The driver of a doubles rig should:

Make slow, gradual steering and braking inputs
Drive aggressively
Use only the trailer brake
Honk frequently

Correct. Smooth, gradual inputs are critical. Avoid abrupt steering and abrupt braking.

Question 9 of 20

When testing the brakes on a doubles rig:

Do all the standard checks plus verify air pressure builds at the rear trailer and that brakes apply at all wheels
Only test the tractor
Only test the lead trailer
Skip the test

Correct. Test the entire rig: build-up time, leakage, low-pressure warning, parking brake, and confirm rear-trailer brake function.

Question 10 of 20

Crosswinds are particularly hazardous for:

Empty doubles and triples
Loaded singles
Backing
Slow speeds

Correct. Empty trailers in a multi-trailer rig present a large flat surface to crosswinds — a strong gust can blow the rear trailer over.

Question 11 of 20

When pulling doubles in a tunnel:

Stay alert; clearance and turning radius can be tight
Drive faster
Stop in the middle
Honk continuously

Correct. Tunnel clearance can be tight for long doubles — watch overhead and side clearance, and respect any vehicle-class restrictions.

Question 12 of 20

A converter-dolly fifth wheel must be:

Properly lubricated and have correctly functioning locking jaws
Painted
Wide
Empty

Correct. Inspect for proper lubrication, no excessive wear, and confirm the locking jaws operate correctly. The dolly fifth wheel is just as critical as the tractor's.

Question 13 of 20

On a triple, the air pressure to the rearmost trailer:

Is the same as the lead
Is delayed by line length, so braking response at the rear trailer lags noticeably
Is faster
Does not exist

Correct. Greater line length = greater brake-lag at the rear. Plan braking earlier than you would for a single trailer.

Question 14 of 20

When inspecting a doubles rig, the lights on the rear of the rear-most trailer must:

Be visible, working, and not blocked by the lead trailer
Only the lead trailer's lights matter
Be off
Not be checked

Correct. Brake, turn, and marker lights at the rear of the rearmost trailer must be working and visible — that is what following traffic sees.

Question 15 of 20

A pintle hook is:

The hitch on the rear of a trailer used to tow another trailer or dolly
The kingpin
The fifth wheel
A type of placard

Correct. The pintle hook is the strong rear-mounted hitch that grips the dolly's lunette eye, allowing one trailer to tow another behind it.

Question 16 of 20

You discover a flat tire on the rear trailer of a triple. You should:

Continue driving
Pull off safely, set warning devices, and have the tire repaired or replaced before continuing
Drive only at night
Drive faster to balance

Correct. A flat tire affects rig stability and brake load. Pull off safely, use warning devices, and address the tire.

Question 17 of 20

A doubles rig is more likely to roll over than a single because:

The center of gravity is higher
The crack-the-whip effect amplifies steering input at the rear, where rollover threshold is lower
It is heavier
It is shorter

Correct. Multi-trailer rollover comes from rearward amplification — even modest steering input at the tractor becomes a violent swing at the rear trailer.

Question 18 of 20

A "set of triples" typically refers to:

One tractor pulling three trailers
Three trailers without a tractor
Three tractors and one trailer
Three tractors only

Correct. A set of triples is one tractor pulling three trailers — usually allowed only on specific designated routes.

Question 19 of 20

During a pre-trip on doubles, the trailer-supply line:

Should be open from tractor to rear-most trailer
Should be open at the front but closed at the rear-most trailer
Should be closed everywhere
Should always be disconnected

Correct. The supply line carries air from tractor through every trailer; verify open valves at every coupled connection and a closed valve at the rear of the rear-most trailer.

Question 20 of 20

The "T" endorsement is required to:

Drive any commercial vehicle
Pull two or more trailers
Drive a bus
Haul hazmat

Correct. The T endorsement is required to pull more than one trailer (doubles or triples).

About the South Carolina Doubles/Triples exam

Most states administer 20 Doubles/Triples questions and require 80% to pass. The exam emphasizes coupling and uncoupling the converter dolly, rearward amplification (the "crack-the-whip" effect), and the unique inspection and handling demands of multi-trailer rigs.

The South Carolina Department of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Doubles/Triples credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Doubles/Triples question bank or browse all South Carolina CDL practice tests.