South Carolina Combination Vehicles CDL Practice Test

This is a free 20-question practice test for the Combination Vehicles portion of the South Carolina Commercial Driver's License knowledge exam. Questions are pulled from a pool of 55 drawn from the AAMVA CDL Manual, which is the source document the South Carolina Department of Motor Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in South Carolina.

Question 1 of 20

A combination-vehicle pre-trip should include:

All single-vehicle items plus fifth wheel, kingpin, sliding fifth wheel/sliding tandem locks, mud flaps, trailer brakes, lights, and trailer tires
Only the tractor
Only the trailer
Only the cargo

Correct. You inspect the entire rig — tractor + trailer + connections + cargo securement — not just the tractor.

Question 2 of 20

A combination vehicle on slippery roads should be driven:

Faster to maintain control
Slower with greater following distance
At normal speed
In a higher gear

Correct. Reduce speed by at least one third on wet roads and one half on snow; double following distance on slick surfaces.

Question 3 of 20

A safe practice when arriving at a destination is to:

Pull straight in fast
Pull straight ahead, slowly, watching mirrors and clearance
Back in without help
Stop on the road

Correct. Slow approach with mirror checks gives time to identify clearance issues and pedestrians.

Question 4 of 20

Before uncoupling, you should:

Park on level ground, set the trailer parking brake, lower the landing gear, disconnect air and electrical lines, then release the fifth-wheel jaws
Just pull away
Disconnect electrical only
Drive forward fast

Correct. Proper sequence: park level, lower landing gear to support the trailer, disconnect lines, release jaws, then pull forward slowly. Skipping any step risks dropping the trailer.

Question 5 of 20

Trailer cargo can shift if:

Securement is inadequate, the load was packed unevenly, or the rig undergoes hard braking or sharp turns
Cargo never shifts
Roads are smooth
Trailer is empty

Correct. Inadequate securement, uneven packing, hard braking, sharp turns, or rough roads can all shift cargo. Inspect cargo periodically en route.

Question 6 of 20

When you "G.O.A.L." in trucking, you:

Get Off And Look — visually verify the area before backing
Go Over A Limit
Grab On And Lift
Greet Other Approaching Loaders

Correct. G.O.A.L. — Get Out And Look — is the universal driver-school rule before any tight backing maneuver.

Question 7 of 20

A sliding-tandem trailer allows you to:

Adjust the trailer-axle position to redistribute weight between trailer axles and tractor drive axles
Speed up
Cool the load
Steer the trailer

Correct. Sliding tandems shift trailer axles forward (more weight on tractor) or aft (more weight on trailer axles), helping meet axle-weight limits.

Question 8 of 20

The air lines connecting the tractor and trailer are:

Red (emergency) and blue (service)
Red and yellow
Blue and yellow
Black and red

Correct. The red glad-hand carries emergency/supply air; the blue glad-hand carries service air. They cross to keep matched colors when coupling.

Question 9 of 20

Off-tracking refers to:

Trailer brakes overheating
Trailer wheels following a tighter path than the tractor wheels in turns
The trailer pulling left
Tires losing tread

Correct. Off-tracking is the tendency for trailer wheels to follow a smaller-radius path than the tractor wheels through a turn, more pronounced with longer wheelbases.

Question 10 of 20

After connecting the trailer, before pulling away, you should always:

Visually inspect the fifth-wheel/kingpin connection from outside the cab
Just trust the gauge
Honk the horn
Set the trailer brake

Correct. Always visually confirm: no gap between fifth wheel and trailer plate, jaws closed around the kingpin shank, locking lever fully in place.

Question 11 of 20

The most likely cause of a tractor jackknife is:

Light cargo
Drive wheels lock during braking
Slow speed
Loose load

Correct. When drive wheels lose traction (locked, oversteer, ice), the tractor pivots ahead of the trailer — a jackknife.

Question 12 of 20

To recover from a trailer skid, you should:

Apply more brakes
Release the brakes to let the trailer wheels regain traction
Steer hard left
Honk

Correct. Release the brakes so the trailer wheels can rotate again and re-establish traction. Continued braking will worsen the skid.

Question 13 of 20

When coupling, after backing under the trailer, you should:

Pull the trailer immediately
Perform a tug test (gently pulling forward in low gear with trailer brakes set) to confirm the kingpin is locked
Disconnect the air lines
Lower the landing gear

Correct. A tug test confirms the kingpin is fully engaged. Skipping it is the leading cause of trailer drops shortly after coupling.

Question 14 of 20

When backing a tractor-trailer in a straight line, you should:

Let the trailer drift wherever it goes
Make small steering corrections to keep the trailer in line
Apply heavy brake pressure
Use the trailer hand valve

Correct. When backing straight, watch the trailer in your mirrors and make small steering corrections to keep it tracking straight. Big corrections lead to jackknifing.

Question 15 of 20

On a tight curve or exit ramp, a tractor-trailer is most likely to roll over because:

The trailer brakes lock
The high center of gravity creates a tipping force greater than the tires can resist
The tractor accelerates
The road is dry

Correct. Centripetal forces in a curve push the cargo outward; a high center of gravity multiplies the tipping moment. Slow before the curve.

Question 16 of 20

When you supply air to the trailer for the first time after coupling, you should:

Wait until air pressure builds in the trailer reservoir, then test the trailer brakes by pulling out the trailer-supply knob
Drive away immediately
Disconnect the lines
Skip the test

Correct. Charge the trailer system. Then test the trailer brake function by tugging gently or pulling the trailer-supply knob to confirm trailer brakes apply.

Question 17 of 20

To make a trailer go where you want when backing, the steering wheel should:

Be turned in the direction you want the trailer to go
Be turned opposite to the direction you want the trailer to go (then corrected)
Stay still
Be held lightly

Correct. Backing is opposite-direction steering: to swing the trailer right, turn the wheel left first, then correct as the trailer follows.

Question 18 of 20

When you turn on a tight radius (e.g., into a tight loading dock):

Off-tracking is exaggerated; the trailer will swing far inside the line of the tractor wheels
Off-tracking disappears
Trailer follows tractor exactly
Trailer goes wide

Correct. On a tight radius, off-tracking is more pronounced. Sweep wide enough that the trailer wheels clear curbs and obstacles.

Question 19 of 20

A sliding fifth wheel that is unlocked or improperly secured can:

Slide unexpectedly during braking or acceleration, dangerously changing handling
Improve fuel economy
Save time
Have no effect

Correct. An unsecured sliding fifth wheel can shift during braking, changing the rig's handling unpredictably. Always verify the lock pin is engaged.

Question 20 of 20

Combination vehicles are usually:

Easier to drive than single trucks
Harder to drive than single trucks because of length, weight, and the unique handling of articulated vehicles
The same as single trucks
Faster than single trucks

Correct. Combination vehicles (tractor-trailer rigs) are heavier, longer, and articulate at the fifth wheel — all making them more demanding than single-unit trucks.

About the South Carolina Combination Vehicles exam

Most states administer 20 Combination Vehicles questions and require 80% to pass. The exam emphasizes the unique handling of articulated vehicles: how trailers track behind the tractor, how to prevent rollover, how to manage rearward amplification with multi-trailer combinations, and the correct sequence to couple and uncouple.

The South Carolina Department of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Combination Vehicles credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Combination Vehicles question bank or browse all South Carolina CDL practice tests.