Rhode Island Doubles/Triples CDL Practice Test

This is a free 20-question practice test for the Doubles/Triples portion of the Rhode Island Commercial Driver's License knowledge exam. Questions are pulled from a pool of 50 drawn from the AAMVA CDL Manual, which is the source document the Rhode Island Division of Motor Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Rhode Island.
Question 1 of 20
When testing the brakes on a doubles rig:
Correct. Test the entire rig: build-up time, leakage, low-pressure warning, parking brake, and confirm rear-trailer brake function.
Question 2 of 20
When pulling doubles in a tunnel:
Correct. Tunnel clearance can be tight for long doubles — watch overhead and side clearance, and respect any vehicle-class restrictions.
Question 3 of 20
A converter dolly is:
Correct. A converter dolly has a small frame, axle(s), and a fifth wheel mounted on top — it transforms a semi-trailer into a full trailer behind another trailer.
Question 4 of 20
You discover a flat tire on the rear trailer of a triple. You should:
Correct. A flat tire affects rig stability and brake load. Pull off safely, use warning devices, and address the tire.
Question 5 of 20
Before connecting a converter dolly, you should:
Correct. Pre-trip the dolly: tires, brake adjustment, fifth-wheel jaws (open and clean), pintle hook, electrical receptacle, lights.
Question 6 of 20
A converter-dolly fifth wheel must be:
Correct. Inspect for proper lubrication, no excessive wear, and confirm the locking jaws operate correctly. The dolly fifth wheel is just as critical as the tractor's.
Question 7 of 20
When pulling a single trailer and trying to figure out if you should add a doubles endorsement:
Correct. The T endorsement is required only when you actually operate doubles or triples. Single-trailer operations do not require it.
Question 8 of 20
During a pre-trip on doubles, the trailer-supply line:
Correct. The supply line carries air from tractor through every trailer; verify open valves at every coupled connection and a closed valve at the rear of the rear-most trailer.
Question 9 of 20
On a steep downgrade with doubles, you should:
Correct. Same rule as any combination vehicle, but plan extra margin: doubles take longer to stop and the rear trailer may push.
Question 10 of 20
Coupling order for a set of doubles starts with:
Correct. Standard order: tractor + lead trailer first, charge air, then attach converter dolly behind lead trailer, then second trailer to dolly.
Question 11 of 20
On a triple, the air pressure to the rearmost trailer:
Correct. Greater line length = greater brake-lag at the rear. Plan braking earlier than you would for a single trailer.
Question 12 of 20
Inspecting safety chains on a converter dolly:
Correct. Safety chains should be intact, no broken links or excessive wear, and properly crossed under the pintle for support.
Question 13 of 20
Triples are restricted in many states. You should:
Correct. Many states restrict triples to specific routes (turnpikes, designated corridors). Verify legality and route before crossing into a state.
Question 14 of 20
The "T" endorsement is required to:
Correct. The T endorsement is required to pull more than one trailer (doubles or triples).
Question 15 of 20
When you uncouple a converter dolly, you should:
Correct. Park level, disconnect air and electric, lower trailer landing gear if applicable, remove safety chains, then release the pintle hook to free the dolly.
Question 16 of 20
When coupling the second trailer to the converter dolly:
Correct. Position dolly, secure to lead-trailer pintle, then back second trailer over the fifth wheel and lock as a normal coupling.
Question 17 of 20
Air pressure on a triple-trailer rig takes:
Correct. Each additional trailer adds line length. Brake response at the rear trailer of a triple is noticeably delayed — brake earlier.
Question 18 of 20
A tractor pulling doubles cannot brake as quickly as a tractor pulling a single trailer because:
Correct. Greater weight and longer air lines mean longer braking distance. Plan stopping distance with extra margin.
Question 19 of 20
Glad-hand shut-off valves at the rear of trailers (for connecting to a following trailer) must be:
Correct. Open the shut-off valves where the next trailer is connected; close them at the rear of the last trailer to prevent air loss.
Question 20 of 20
When pulling a heavy lead trailer and a light second trailer, the rig:
Correct. Heaviest in front, lightest in rear. Heavy at the rear amplifies crack-the-whip and rollover risk.

About the Rhode Island Doubles/Triples exam

Most states administer 20 Doubles/Triples questions and require 80% to pass. The exam emphasizes coupling and uncoupling the converter dolly, rearward amplification (the "crack-the-whip" effect), and the unique inspection and handling demands of multi-trailer rigs.

The Rhode Island Division of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Doubles/Triples credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Doubles/Triples question bank or browse all Rhode Island CDL practice tests.