Ohio Doubles/Triples CDL Practice Test

This is a free 20-question practice test for the Doubles/Triples portion of the Ohio Commercial Driver's License knowledge exam. Questions are pulled from a pool of 50 drawn from the AAMVA CDL Manual, which is the source document the Ohio Bureau of Motor Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Ohio.

Question 1 of 20

Triples are restricted in many states. You should:

Drive triples anywhere
Verify state-by-state legality before crossing into a state
Use a special placard
Avoid driving in cities

Correct. Many states restrict triples to specific routes (turnpikes, designated corridors). Verify legality and route before crossing into a state.

Question 2 of 20

When pulling triples, you should:

Make abrupt lane changes
Drive in the right lane and avoid abrupt steering
Drive in the left lane
Drive at top speed

Correct. Stay right, plan lane changes well in advance, signal early, and avoid abrupt steering. Triples crack-the-whip violently.

Question 3 of 20

The "T" endorsement is required to:

Drive any commercial vehicle
Pull two or more trailers
Drive a bus
Haul hazmat

Correct. The T endorsement is required to pull more than one trailer (doubles or triples).

Question 4 of 20

A converter dolly is:

A small hand truck
A set of axles with a fifth wheel that converts a semi-trailer into a full trailer for use in doubles/triples
A trailer-loading device
A type of brake

Correct. A converter dolly has a small frame, axle(s), and a fifth wheel mounted on top — it transforms a semi-trailer into a full trailer behind another trailer.

Question 5 of 20

A tractor pulling doubles cannot brake as quickly as a tractor pulling a single trailer because:

Doubles are heavier and brake response is delayed in longer air lines
Doubles are lighter
Brakes are bigger
Tractors brake better with doubles

Correct. Greater weight and longer air lines mean longer braking distance. Plan stopping distance with extra margin.

Question 6 of 20

A safe practice when starting from a stop with doubles:

Accelerate gently to avoid breakaway sway in the second trailer
Floor the accelerator
Use only the trailer hand valve
Skip first gear

Correct. Sudden acceleration can cause the rear trailer to sway. Start gently in low gear.

Question 7 of 20

Air pressure on a triple-trailer rig takes:

Less time to reach the rear trailer than on a single
Significantly more time to reach the rear trailer's brake chambers
The same time
No air pressure is needed

Correct. Each additional trailer adds line length. Brake response at the rear trailer of a triple is noticeably delayed — brake earlier.

Question 8 of 20

When pulling a heavy lead trailer and a light second trailer, the rig:

Will be more stable than the reverse
Is more likely to roll the rear trailer
Is illegal
Drives the same as either order

Correct. Heaviest in front, lightest in rear. Heavy at the rear amplifies crack-the-whip and rollover risk.

Question 9 of 20

The driver of a doubles rig should:

Make slow, gradual steering and braking inputs
Drive aggressively
Use only the trailer brake
Honk frequently

Correct. Smooth, gradual inputs are critical. Avoid abrupt steering and abrupt braking.

Question 10 of 20

Coupling order for a set of doubles starts with:

Coupling the lead (front) trailer to the tractor first, charging air, then attaching the converter dolly to the rear of the lead trailer, then attaching the second trailer
Coupling the rear trailer first
Coupling the dolly first
It does not matter

Correct. Standard order: tractor + lead trailer first, charge air, then attach converter dolly behind lead trailer, then second trailer to dolly.

Question 11 of 20

Crosswinds are particularly hazardous for:

Empty doubles and triples
Loaded singles
Backing
Slow speeds

Correct. Empty trailers in a multi-trailer rig present a large flat surface to crosswinds — a strong gust can blow the rear trailer over.

Question 12 of 20

You discover a flat tire on the rear trailer of a triple. You should:

Continue driving
Pull off safely, set warning devices, and have the tire repaired or replaced before continuing
Drive only at night
Drive faster to balance

Correct. A flat tire affects rig stability and brake load. Pull off safely, use warning devices, and address the tire.

Question 13 of 20

When you uncouple a converter dolly, you should:

Disconnect air and electrical, secure or remove safety chains, then release the pintle hook
Just yank it off
Drive forward fast
Use only the trailer brake

Correct. Park level, disconnect air and electric, lower trailer landing gear if applicable, remove safety chains, then release the pintle hook to free the dolly.

Question 14 of 20

Inspecting safety chains on a converter dolly:

Verify they are correctly crossed and have no broken links, deformations, or wear
Skip the chains
Replace them daily
Verify color only

Correct. Safety chains should be intact, no broken links or excessive wear, and properly crossed under the pintle for support.

Question 15 of 20

In a multi-trailer combination, the most violent movement during evasive maneuvers happens at:

The tractor
The first trailer
The last trailer
The cab

Correct. Rearward amplification (crack-the-whip effect) is greatest at the rear-most trailer. The last trailer in a triple can be thrown sideways with much greater force than the tractor.

Question 16 of 20

When making a lane change in a doubles rig, you should:

Signal early, check mirrors, change lanes gradually
Snap the wheel
Use only the trailer hand valve
Skip the signal

Correct. Early signal, mirror check, gradual lane change. Quick lane changes amplify into the rear trailer.

Question 17 of 20

Drivers should always couple the heaviest trailer:

Behind the tractor (in the front position)
At the rear
In the middle
It does not matter

Correct. Heaviest trailer goes directly behind the tractor; lightest goes at the rear. This minimizes rearward amplification and rollover risk.

Question 18 of 20

When inspecting a doubles or triples rig, you should additionally check:

Each pintle hook, each set of safety chains, each converter dolly, each trailer's lights, brake chamber connections, glad-hands, and shut-off valves
Only the lead trailer
Only the tractor
Only the cargo

Correct. Every connection point and every trailer needs inspection — pintle hooks, chains, dollies, lights, brake lines, glad-hands, and air-supply valves.

Question 19 of 20

When coupling the second trailer to the converter dolly:

Position the dolly in front of the second trailer, lower trailer landing gear if necessary, lock the dolly to the lead trailer's pintle hook with safety chains, then back the second trailer onto the fifth wheel
Just push them together
Use the trailer hand valve
Drive past it fast

Correct. Position dolly, secure to lead-trailer pintle, then back second trailer over the fifth wheel and lock as a normal coupling.

Question 20 of 20

A "drive-axle skid" on a doubles rig:

Can lead to a tractor jackknife and complicated trailer movement behind it
Is harmless
Means the dolly broke
Increases stability

Correct. A drive-axle skid leads to tractor jackknife. With trailers behind, the situation gets worse fast — the rear trailers can swing wildly.

About the Ohio Doubles/Triples exam

Most states administer 20 Doubles/Triples questions and require 80% to pass. The exam emphasizes coupling and uncoupling the converter dolly, rearward amplification (the "crack-the-whip" effect), and the unique inspection and handling demands of multi-trailer rigs.

The Ohio Bureau of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Doubles/Triples credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Doubles/Triples question bank or browse all Ohio CDL practice tests.