Ohio Air Brakes CDL Practice Test

This is a free 20-question practice test for the Air Brakes portion of the Ohio Commercial Driver's License knowledge exam. Questions are pulled from a pool of 71 drawn from the AAMVA CDL Manual, which is the source document the Ohio Bureau of Motor Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Ohio.

Question 1 of 20

You should never leave the vehicle unattended without:

Locking the doors
Applying the parking brakes and chocking the wheels if necessary
Turning off the radio
Removing the key

Correct. Set the parking brake. On grades or where unintended movement could occur, chock the wheels in addition.

Question 2 of 20

The parts of an air-brake system include:

Air compressor, governor, air storage tanks, foot valve, and brake chambers
Master cylinder, brake fluid, and calipers
Hydraulic pump, lines, and disc rotors
Vacuum booster and reservoir

Correct. Air-brake systems use a compressor, governor, storage tanks, foot valve, and brake chambers — distinct from hydraulic systems used in cars.

Question 3 of 20

Antilock braking systems (ABS):

Replace the regular brakes
Help prevent wheel lockup so you can keep steering during emergency braking
Reduce braking distance under normal conditions
Are not required on combination vehicles

Correct. ABS prevents wheel lockup during hard braking, allowing you to steer to safety. ABS does not necessarily shorten stopping distance.

Question 4 of 20

The brake-system warning light or buzzer is designed to alert you when:

The brakes are working
Air pressure has dropped below the level needed to brake safely
Brake fluid is low
You haven't serviced the brakes recently

Correct. The brake-system warning device alerts you to dangerous low air pressure — typically activating at or before 60 psi.

Question 5 of 20

A long downgrade requires:

Riding the brakes the whole way
Selecting a low gear before starting down and using intermittent firm brake applications
Coasting in neutral
Using the engine brake only

Correct. Pick a low gear before starting down. Use the brakes in firm, intermittent applications: brake to 5 mph below safe speed, release, repeat.

Question 6 of 20

A yellow ABS malfunction lamp on the cab dash means:

Everything is fine
The ABS on the tractor is malfunctioning
The trailer ABS is malfunctioning
Air pressure is low

Correct. A yellow ABS lamp on the dash indicates a tractor-ABS malfunction. The base brakes still work normally, but ABS is unavailable until repaired.

Question 7 of 20

The governor controls:

Engine RPM
When the air compressor pumps air into the air storage tanks
Brake-pedal travel
Trailer hand-valve operation

Correct. The governor cycles the compressor: it cuts the compressor in around 100 psi and cuts it out around 125 psi.

Question 8 of 20

The application pressure gauge shows:

The pressure in the storage tanks
How much pressure is being applied to the brakes when you press the foot valve
Tire pressure
Engine oil pressure

Correct. The application gauge (when present) shows brake-application pressure — useful for spotting brake-system problems on long downgrades.

Question 9 of 20

Pre-trip air-brake check (Step 1) is to:

Test the parking brake
Test the air leakage rate
Time the air-pressure build-up
Check the slack adjusters

Correct. In the seven-step air-brake check the first step is testing the parking brake — release service brakes, set parking brake, gently try to move the vehicle in low gear.

Question 10 of 20

The "tractor protection valve" closes (cuts off air to the trailer) automatically when:

You apply the brakes
Air pressure in the tractor drops to a dangerously low level (typically 20 to 45 psi)
You hit a bump
You shift gears

Correct. The tractor protection valve protects the tractor from a runaway air loss in case of a trailer break-away or air leak — it closes between 20 and 45 psi.

Question 11 of 20

When the air-pressure protection valve closes during driving (because pressure dropped too low), the trailer:

Continues without effect
Spring brakes apply, and the trailer stops
Loses electrical power
Turns off its lights

Correct. When tractor air pressure falls into the 20-45 psi range, the protection valve closes, cutting trailer air, which causes the trailer spring brakes to apply.

Question 12 of 20

The S-cam:

Is a type of fuel pump
Forces the brake shoes against the drum to provide braking action
Adjusts the slack adjuster
Is the parking-brake control

Correct. When the foot valve is pressed, air pushes the brake-chamber pushrod, which moves the slack adjuster, which rotates the S-cam shaft, forcing the shoes against the drum.

Question 13 of 20

Manual slack adjusters must be adjusted:

Only by a mechanic at the dealership
By the driver, when needed, following manufacturer specifications
Never
Only at the time of vehicle inspection

Correct. Drivers may adjust manual slack adjusters in compliance with manufacturer specifications. Automatic slack adjusters are now standard but still require periodic checking.

Question 14 of 20

Stopping distance for a vehicle with air brakes is the sum of:

Perception distance + reaction distance + brake-lag distance + braking distance
Brake-lag only
Reaction time only
Braking distance only

Correct. Air-brake stopping distance is perception + reaction + brake lag + braking — the brake lag is the unique addition.

Question 15 of 20

You hear a steady "ssss" sound while parked with the engine off. This is most likely:

Normal venting
An air leak that needs immediate attention
The compressor running
Trailer brakes releasing

Correct. A steady hiss with the engine off indicates an air leak — find and repair before driving.

Question 16 of 20

The "brake-system warning device" must come on no later than:

10 psi
30 psi
60 psi
100 psi

Correct. A federal-rule low-air-pressure warning device must activate at or before 60 psi.

Question 17 of 20

Air-brake disc brakes use:

Air to apply force to a clamp on a rotating disc, instead of a drum
Hydraulic fluid
A separate fuel system
Spring force only

Correct. Disc brakes use a brake chamber and slack adjuster like S-cam drum brakes, but the force closes a caliper on a rotor instead of forcing shoes against a drum.

Question 18 of 20

When releasing brakes after a hard stop, you should:

Continue holding the brakes
Release smoothly to allow air to refill the tanks
Pump the brakes
Apply the parking brake immediately

Correct. Release the brakes smoothly. Air tanks refill while you drive; allow the compressor to recharge the system before the next braking event.

Question 19 of 20

A low-air-pressure warning device must come on at or before:

20 psi
40 psi
60 psi
80 psi

Correct. A federal-mandated low-air-pressure warning (light, buzzer, or wig-wag) must activate at or before 60 psi.

Question 20 of 20

A condition called "brake fade" is most likely on:

Long downgrades
Flat highway
Backing into a dock
Fueling

Correct. Brake fade comes from heat from extended use — most commonly on long, steep downgrades where the brakes are working continuously.

About the Ohio Air Brakes exam

States typically administer 25 Air Brakes questions and require 80% to pass. Questions cover air-brake system parts, dual systems, supply pressure, brake-system warning, slack adjusters, the parking brake, the spring brake, the pre-trip air-system check, and the proper way to perform a leakage-rate test.

The Ohio Bureau of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Air Brakes credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Air Brakes question bank or browse all Ohio CDL practice tests.