North Dakota Doubles/Triples CDL Practice Test

This is a free 20-question practice test for the Doubles/Triples portion of the North Dakota Commercial Driver's License knowledge exam. Questions are pulled from a pool of 50 drawn from the AAMVA CDL Manual, which is the source document the North Dakota Department of Transportation Drivers License Division uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in North Dakota.
Question 1 of 20
When traveling on bridges with weight or length limits:
Correct. Multi-trailer rigs may exceed length or weight limits on certain bridges. Plan routes to comply with posted limits.
Question 2 of 20
When pulling triples, you should:
Correct. Stay right, plan lane changes well in advance, signal early, and avoid abrupt steering. Triples crack-the-whip violently.
Question 3 of 20
Before connecting a converter dolly, you should:
Correct. Pre-trip the dolly: tires, brake adjustment, fifth-wheel jaws (open and clean), pintle hook, electrical receptacle, lights.
Question 4 of 20
When you uncouple a converter dolly, you should:
Correct. Park level, disconnect air and electric, lower trailer landing gear if applicable, remove safety chains, then release the pintle hook to free the dolly.
Question 5 of 20
In a multi-trailer combination, the most violent movement during evasive maneuvers happens at:
Correct. Rearward amplification (crack-the-whip effect) is greatest at the rear-most trailer. The last trailer in a triple can be thrown sideways with much greater force than the tractor.
Question 6 of 20
When uncoupling the converter dolly from the lead trailer:
Correct. Standard sequence: support the trailer (landing gear if it is a semi-trailer), disconnect lines, remove chains, release pintle hook.
Question 7 of 20
During a pre-trip on doubles, the trailer-supply line:
Correct. The supply line carries air from tractor through every trailer; verify open valves at every coupled connection and a closed valve at the rear of the rear-most trailer.
Question 8 of 20
Driving doubles or triples on the highway:
Correct. Multi-trailer rigs are more sensitive to abrupt steering, take longer to brake, and amplify any movement to the rear. Be gentle and plan ahead.
Question 9 of 20
A doubles rig is more likely to roll over than a single because:
Correct. Multi-trailer rollover comes from rearward amplification — even modest steering input at the tractor becomes a violent swing at the rear trailer.
Question 10 of 20
A tractor pulling doubles cannot brake as quickly as a tractor pulling a single trailer because:
Correct. Greater weight and longer air lines mean longer braking distance. Plan stopping distance with extra margin.
Question 11 of 20
A "set of doubles" typically refers to:
Correct. A "set of doubles" is one tractor pulling two trailers (typically two pups, each about 28 feet long, in LTL operations).
Question 12 of 20
Air pressure on a triple-trailer rig takes:
Correct. Each additional trailer adds line length. Brake response at the rear trailer of a triple is noticeably delayed — brake earlier.
Question 13 of 20
On a steep downgrade with doubles, you should:
Correct. Same rule as any combination vehicle, but plan extra margin: doubles take longer to stop and the rear trailer may push.
Question 14 of 20
When inspecting a doubles or triples rig, you should additionally check:
Correct. Every connection point and every trailer needs inspection — pintle hooks, chains, dollies, lights, brake lines, glad-hands, and air-supply valves.
Question 15 of 20
The "T" endorsement is required to:
Correct. The T endorsement is required to pull more than one trailer (doubles or triples).
Question 16 of 20
When pulling a heavy lead trailer and a light second trailer, the rig:
Correct. Heaviest in front, lightest in rear. Heavy at the rear amplifies crack-the-whip and rollover risk.
Question 17 of 20
Triples are restricted in many states. You should:
Correct. Many states restrict triples to specific routes (turnpikes, designated corridors). Verify legality and route before crossing into a state.
Question 18 of 20
When inspecting a converter dolly, the pintle hook must:
Correct. The pintle hook must close fully around the lunette eye, with no excessive wear or cracks. Add safety chains as backup.
Question 19 of 20
A driver licensed for Class A with all endorsements may drive any combination vehicle. The T endorsement allows:
Correct. T endorsement specifically authorizes doubles and triples. Other endorsements (H, N, P, S) cover other categories.
Question 20 of 20
Crosswinds are particularly hazardous for:
Correct. Empty trailers in a multi-trailer rig present a large flat surface to crosswinds — a strong gust can blow the rear trailer over.

About the North Dakota Doubles/Triples exam

Most states administer 20 Doubles/Triples questions and require 80% to pass. The exam emphasizes coupling and uncoupling the converter dolly, rearward amplification (the "crack-the-whip" effect), and the unique inspection and handling demands of multi-trailer rigs.

The North Dakota Department of Transportation Drivers License Division follows the federal CDL standards established by FMCSA. To earn the Doubles/Triples credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Doubles/Triples question bank or browse all North Dakota CDL practice tests.