New Jersey Combination Vehicles CDL Practice Test

This is a free 20-question practice test for the Combination Vehicles portion of the New Jersey Commercial Driver's License knowledge exam. Questions are pulled from a pool of 55 drawn from the AAMVA CDL Manual, which is the source document the New Jersey Motor Vehicle Commission uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in New Jersey.

Question 1 of 20

The trailer hand valve should be used:

Only to test the trailer brakes; never to slow the rig in normal driving
To slow the rig in all conditions
To brake on slick roads
Continuously on long downgrades

Correct. Use the trailer hand valve only for testing trailer brakes. Using it to slow the rig can cause the trailer to skid or jackknife.

Question 2 of 20

Auxiliary equipment (refrigeration, hydraulic lift gates) on the trailer:

Has no effect on the rig
Adds weight and may change rear-axle loading; verify securement and operation
Replaces the brakes
Cannot be operated while loaded

Correct. Reefer units, lift gates, and other auxiliary equipment add weight and may shift CG. Inspect securement and check operation in pre-trip.

Question 3 of 20

A jackknife happens when:

The trailer wheels skid while the tractor continues forward
The tractor pulls forward in a straight line
The trailer slides sideways while the tractor pivots
The driver brakes too lightly

Correct. Jackknife is when the drive wheels skid and the trailer continues forward, causing the tractor to pivot — the rig folds at the fifth wheel like a closing knife.

Question 4 of 20

Trailer rollover is more likely when:

Cargo is loaded low and centered
Cargo is loaded high or to one side, raising the center of gravity
Cargo is light
Trailer is empty

Correct. High cargo and uneven side-loading raise the center of gravity, increasing rollover risk on curves and ramps.

Question 5 of 20

The "rearward amplification" effect:

Is greatest in the lead trailer
Is greatest in the rear-most trailer of doubles or triples
Does not exist
Is the same in every trailer

Correct. Rearward amplification — the crack-the-whip effect — is most severe in the rear trailer of a multi-trailer combination.

Question 6 of 20

When you check the fifth wheel during pre-trip, you look for:

Mounting to the frame is secure, no missing or damaged parts, no visible space between the upper and lower fifth-wheel plates, locking jaws around the kingpin shank, release arm in the locked position
Only the color
Only the bolts
Only the grease

Correct. Check mount, condition, gap, jaw engagement around kingpin shank (not the head), and release-arm lock position. Lubrication should be present but not excessive.

Question 7 of 20

After connecting the trailer, before pulling away, you should always:

Visually inspect the fifth-wheel/kingpin connection from outside the cab
Just trust the gauge
Honk the horn
Set the trailer brake

Correct. Always visually confirm: no gap between fifth wheel and trailer plate, jaws closed around the kingpin shank, locking lever fully in place.

Question 8 of 20

When approaching a curve in a tractor-trailer, you should:

Brake during the curve
Slow down before entering the curve
Speed up
Maintain steady speed

Correct. Slow before entering the curve. Once in the curve, accelerate gently to maintain stability. Braking in a curve invites trailer skid or rollover.

Question 9 of 20

During a pre-trip inspection, you should also check that the cargo:

Is loaded inside the vehicle
Is secured, balanced, within weight limits, and within size limits
Is brightly colored
Is all the same shape

Correct. Cargo securement, weight balance, and size compliance are all driver responsibilities — check before each trip.

Question 10 of 20

Trailer wheels off-track:

Outside the path of the tractor wheels
Inside (tighter turn radius) than the tractor wheels
At the same path as the tractor wheels
Cannot be predicted

Correct. Trailer wheels follow a tighter path than tractor wheels through a turn — off-tracking. Plan turns to keep trailer tires on the pavement and clear of curbs.

Question 11 of 20

A "trailer skid" happens when:

Trailer wheels lose traction and the trailer slides outward
Tractor wheels lock
Brakes overheat
Cargo shifts

Correct. When trailer wheels lose traction (often from over-application of trailer brakes alone), the trailer can slide sideways — a trailer skid or trailer swing.

Question 12 of 20

Most jackknifes happen because:

Drive wheels skid during braking on slippery surfaces
Brakes work too well
The road is dry
Cargo is too light

Correct. Loss of traction on the tractor drive axles during braking — typically on slick surfaces or with overly aggressive braking — causes a jackknife.

Question 13 of 20

Length and weight increase what about a combination vehicle?

Stopping distance, off-tracking, blind spots, and time required for lane changes
Visibility
Speed
Acceleration

Correct. Longer, heavier rigs need more stopping distance, swing wider in turns, have larger blind spots, and require more time and space to change lanes.

Question 14 of 20

A sliding fifth wheel allows you to:

Adjust the weight distribution between drive axles and trailer axles
Speed up
Slow down
Disable the trailer brakes

Correct. Sliding fifth wheels move forward to put more weight on drive axles or aft to reduce drive-axle weight, helping comply with axle-weight limits.

Question 15 of 20

When you couple, the locking jaws of the fifth wheel must close around:

The kingpin shank, not just the head
Just the head
The trailer skirt
The wheel

Correct. The locking jaws must engage the kingpin shank below the head. If the jaws close above the head, the connection is unsafe.

Question 16 of 20

When uncoupling, you should lower the landing gear:

After releasing the jaws
Before releasing the jaws so the trailer is supported when you pull away
Halfway
Not at all

Correct. Lower the landing gear and snug it against the ground before releasing the fifth-wheel jaws so the trailer doesn't drop when you pull away.

Question 17 of 20

A sliding-tandem trailer allows you to:

Adjust the trailer-axle position to redistribute weight between trailer axles and tractor drive axles
Speed up
Cool the load
Steer the trailer

Correct. Sliding tandems shift trailer axles forward (more weight on tractor) or aft (more weight on trailer axles), helping meet axle-weight limits.

Question 18 of 20

Trailer cargo can shift if:

Securement is inadequate, the load was packed unevenly, or the rig undergoes hard braking or sharp turns
Cargo never shifts
Roads are smooth
Trailer is empty

Correct. Inadequate securement, uneven packing, hard braking, sharp turns, or rough roads can all shift cargo. Inspect cargo periodically en route.

Question 19 of 20

Combination vehicles are usually:

Easier to drive than single trucks
Harder to drive than single trucks because of length, weight, and the unique handling of articulated vehicles
The same as single trucks
Faster than single trucks

Correct. Combination vehicles (tractor-trailer rigs) are heavier, longer, and articulate at the fifth wheel — all making them more demanding than single-unit trucks.

Question 20 of 20

When making a right turn at an intersection in a tractor-trailer:

Swing to the left first to make room for the right turn
Make the turn from the right lane and swing wide as needed at the end of the turn
Make the turn at high speed
Stay in the left lane through the turn

Correct. Make the turn from the right lane. If you must swing wide, do so as you complete the turn, never before — swinging left first invites a vehicle to pass on your right.

About the New Jersey Combination Vehicles exam

Most states administer 20 Combination Vehicles questions and require 80% to pass. The exam emphasizes the unique handling of articulated vehicles: how trailers track behind the tractor, how to prevent rollover, how to manage rearward amplification with multi-trailer combinations, and the correct sequence to couple and uncouple.

The New Jersey Motor Vehicle Commission follows the federal CDL standards established by FMCSA. To earn the Combination Vehicles credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Combination Vehicles question bank or browse all New Jersey CDL practice tests.