Nevada Doubles/Triples CDL Practice Test

This is a free 20-question practice test for the Doubles/Triples portion of the Nevada Commercial Driver's License knowledge exam. Questions are pulled from a pool of 50 drawn from the AAMVA CDL Manual, which is the source document the Nevada Department of Motor Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Nevada.

Question 1 of 20

When pulling triples, you should:

Make abrupt lane changes
Drive in the right lane and avoid abrupt steering
Drive in the left lane
Drive at top speed

Correct. Stay right, plan lane changes well in advance, signal early, and avoid abrupt steering. Triples crack-the-whip violently.

Question 2 of 20

When you uncouple a converter dolly, you should:

Disconnect air and electrical, secure or remove safety chains, then release the pintle hook
Just yank it off
Drive forward fast
Use only the trailer brake

Correct. Park level, disconnect air and electric, lower trailer landing gear if applicable, remove safety chains, then release the pintle hook to free the dolly.

Question 3 of 20

Triples are restricted in many states. You should:

Drive triples anywhere
Verify state-by-state legality before crossing into a state
Use a special placard
Avoid driving in cities

Correct. Many states restrict triples to specific routes (turnpikes, designated corridors). Verify legality and route before crossing into a state.

Question 4 of 20

During a pre-trip on doubles, the trailer-supply line:

Should be open from tractor to rear-most trailer
Should be open at the front but closed at the rear-most trailer
Should be closed everywhere
Should always be disconnected

Correct. The supply line carries air from tractor through every trailer; verify open valves at every coupled connection and a closed valve at the rear of the rear-most trailer.

Question 5 of 20

A "set of doubles" typically refers to:

A tractor pulling two trailers
One tractor with one long trailer
Two tractors and a trailer
Two tractors and two trailers

Correct. A "set of doubles" is one tractor pulling two trailers (typically two pups, each about 28 feet long, in LTL operations).

Question 6 of 20

When parking a doubles rig:

Park where you can pull straight out — back-out is impractical
Back into any spot
Park in the entrance
Block the lane

Correct. Choose pull-through parking. Multi-trailer rigs cannot back any meaningful distance safely.

Question 7 of 20

A safe practice when starting from a stop with doubles:

Accelerate gently to avoid breakaway sway in the second trailer
Floor the accelerator
Use only the trailer hand valve
Skip first gear

Correct. Sudden acceleration can cause the rear trailer to sway. Start gently in low gear.

Question 8 of 20

When inspecting a doubles or triples rig, you should additionally check:

Each pintle hook, each set of safety chains, each converter dolly, each trailer's lights, brake chamber connections, glad-hands, and shut-off valves
Only the lead trailer
Only the tractor
Only the cargo

Correct. Every connection point and every trailer needs inspection — pintle hooks, chains, dollies, lights, brake lines, glad-hands, and air-supply valves.

Question 9 of 20

When uncoupling the converter dolly from the lead trailer:

Lower trailer landing gear (if applicable), disconnect air and electrical, remove safety chains, then release pintle hook
Just unhook the chains and pull away
Drive forward fast
Use only the trailer brake

Correct. Standard sequence: support the trailer (landing gear if it is a semi-trailer), disconnect lines, remove chains, release pintle hook.

Question 10 of 20

A "set of triples" typically refers to:

One tractor pulling three trailers
Three trailers without a tractor
Three tractors and one trailer
Three tractors only

Correct. A set of triples is one tractor pulling three trailers — usually allowed only on specific designated routes.

Question 11 of 20

When pulling a heavy lead trailer and a light second trailer, the rig:

Will be more stable than the reverse
Is more likely to roll the rear trailer
Is illegal
Drives the same as either order

Correct. Heaviest in front, lightest in rear. Heavy at the rear amplifies crack-the-whip and rollover risk.

Question 12 of 20

Glad-hand shut-off valves at the rear of trailers (for connecting to a following trailer) must be:

Open at the rear of the rear-most trailer
Open at the rear of any trailer that has another trailer behind it; closed at the rear of the last trailer
Always closed
Always open

Correct. Open the shut-off valves where the next trailer is connected; close them at the rear of the last trailer to prevent air loss.

Question 13 of 20

When pulling doubles in a tunnel:

Stay alert; clearance and turning radius can be tight
Drive faster
Stop in the middle
Honk continuously

Correct. Tunnel clearance can be tight for long doubles — watch overhead and side clearance, and respect any vehicle-class restrictions.

Question 14 of 20

In a multi-trailer combination, the most violent movement during evasive maneuvers happens at:

The tractor
The first trailer
The last trailer
The cab

Correct. Rearward amplification (crack-the-whip effect) is greatest at the rear-most trailer. The last trailer in a triple can be thrown sideways with much greater force than the tractor.

Question 15 of 20

A pintle hook is:

The hitch on the rear of a trailer used to tow another trailer or dolly
The kingpin
The fifth wheel
A type of placard

Correct. The pintle hook is the strong rear-mounted hitch that grips the dolly's lunette eye, allowing one trailer to tow another behind it.

Question 16 of 20

You discover a flat tire on the rear trailer of a triple. You should:

Continue driving
Pull off safely, set warning devices, and have the tire repaired or replaced before continuing
Drive only at night
Drive faster to balance

Correct. A flat tire affects rig stability and brake load. Pull off safely, use warning devices, and address the tire.

Question 17 of 20

Crosswinds are particularly hazardous for:

Empty doubles and triples
Loaded singles
Backing
Slow speeds

Correct. Empty trailers in a multi-trailer rig present a large flat surface to crosswinds — a strong gust can blow the rear trailer over.

Question 18 of 20

A converter-dolly fifth wheel must be:

Properly lubricated and have correctly functioning locking jaws
Painted
Wide
Empty

Correct. Inspect for proper lubrication, no excessive wear, and confirm the locking jaws operate correctly. The dolly fifth wheel is just as critical as the tractor's.

Question 19 of 20

Before connecting a converter dolly, you should:

Inspect tires, brakes, fifth-wheel jaws, and overall condition
Skip inspection
Only check the tires
Only check the lights

Correct. Pre-trip the dolly: tires, brake adjustment, fifth-wheel jaws (open and clean), pintle hook, electrical receptacle, lights.

Question 20 of 20

A converter dolly is:

A small hand truck
A set of axles with a fifth wheel that converts a semi-trailer into a full trailer for use in doubles/triples
A trailer-loading device
A type of brake

Correct. A converter dolly has a small frame, axle(s), and a fifth wheel mounted on top — it transforms a semi-trailer into a full trailer behind another trailer.

About the Nevada Doubles/Triples exam

Most states administer 20 Doubles/Triples questions and require 80% to pass. The exam emphasizes coupling and uncoupling the converter dolly, rearward amplification (the "crack-the-whip" effect), and the unique inspection and handling demands of multi-trailer rigs.

The Nevada Department of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Doubles/Triples credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Doubles/Triples question bank or browse all Nevada CDL practice tests.