Montana Combination Vehicles CDL Practice Test

This is a free 20-question practice test for the Combination Vehicles portion of the Montana Commercial Driver's License knowledge exam. Questions are pulled from a pool of 55 drawn from the AAMVA CDL Manual, which is the source document the Montana Motor Vehicle Division uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Montana.

Question 1 of 20

Cargo securement: the heaviest part of the load should be:

Loaded over the front axle area, with weight evenly distributed side to side
Loaded at the rear
Loaded on one side
Stacked on top

Correct. Loading heavy cargo to the front of the trailer over the drive axles helps with traction; loading to one side or top creates dangerous handling.

Question 2 of 20

When coupling, after backing under the trailer, you should:

Pull the trailer immediately
Perform a tug test (gently pulling forward in low gear with trailer brakes set) to confirm the kingpin is locked
Disconnect the air lines
Lower the landing gear

Correct. A tug test confirms the kingpin is fully engaged. Skipping it is the leading cause of trailer drops shortly after coupling.

Question 3 of 20

Your trailer ABS warning lamp is on. The trailer service brakes:

Will not work at all
Still work normally — only ABS function is unavailable
Lock up
Apply automatically

Correct. Trailer service brakes still work normally without ABS. Have the system repaired; ABS gives extra control during emergency braking.

Question 4 of 20

When you turn on a tight radius (e.g., into a tight loading dock):

Off-tracking is exaggerated; the trailer will swing far inside the line of the tractor wheels
Off-tracking disappears
Trailer follows tractor exactly
Trailer goes wide

Correct. On a tight radius, off-tracking is more pronounced. Sweep wide enough that the trailer wheels clear curbs and obstacles.

Question 5 of 20

A jackknife happens when:

The trailer wheels skid while the tractor continues forward
The tractor pulls forward in a straight line
The trailer slides sideways while the tractor pivots
The driver brakes too lightly

Correct. Jackknife is when the drive wheels skid and the trailer continues forward, causing the tractor to pivot — the rig folds at the fifth wheel like a closing knife.

Question 6 of 20

If the trailer is too low for coupling, you should:

Crank the trailer up with the landing gear before backing under
Skip the inspection
Drive faster
Use the trailer brake

Correct. Use the landing gear hand crank to raise the trailer to the proper height (just below fifth-wheel level) before backing under.

Question 7 of 20

Length and weight increase what about a combination vehicle?

Stopping distance, off-tracking, blind spots, and time required for lane changes
Visibility
Speed
Acceleration

Correct. Longer, heavier rigs need more stopping distance, swing wider in turns, have larger blind spots, and require more time and space to change lanes.

Question 8 of 20

On a slippery surface, drive in:

Higher gears at higher RPM
A gear that minimizes torque to the drive wheels and brake earlier and gentler
The lowest gear
Whatever is fastest

Correct. Reduce engine power to drive wheels (higher gear, gentler accelerator) and brake earlier and gentler to avoid wheel spin or skid.

Question 9 of 20

Maximum allowable trailer-brake leakage rate (engine off, brakes released, combination vehicle) is:

1 psi/min
3 psi/min
5 psi/min
7 psi/min

Correct. Combination vehicles: no more than 3 psi/min with brakes released, 4 psi/min with brakes applied.

Question 10 of 20

During a pre-trip inspection, you should also check that the cargo:

Is loaded inside the vehicle
Is secured, balanced, within weight limits, and within size limits
Is brightly colored
Is all the same shape

Correct. Cargo securement, weight balance, and size compliance are all driver responsibilities — check before each trip.

Question 11 of 20

On a tight curve or exit ramp, a tractor-trailer is most likely to roll over because:

The trailer brakes lock
The high center of gravity creates a tipping force greater than the tires can resist
The tractor accelerates
The road is dry

Correct. Centripetal forces in a curve push the cargo outward; a high center of gravity multiplies the tipping moment. Slow before the curve.

Question 12 of 20

After connecting the trailer, before pulling away, you should always:

Visually inspect the fifth-wheel/kingpin connection from outside the cab
Just trust the gauge
Honk the horn
Set the trailer brake

Correct. Always visually confirm: no gap between fifth wheel and trailer plate, jaws closed around the kingpin shank, locking lever fully in place.

Question 13 of 20

When inspecting the kingpin during pre-trip, look for:

Excessive wear, bending, cracks, or improper lock-jaw engagement
Only the color
Only the size
Only the grease

Correct. A worn, cracked, or bent kingpin can fail under load. The locking jaws must close completely around the shank, not just the head.

Question 14 of 20

To recover from a trailer skid, you should:

Apply more brakes
Release the brakes to let the trailer wheels regain traction
Steer hard left
Honk

Correct. Release the brakes so the trailer wheels can rotate again and re-establish traction. Continued braking will worsen the skid.

Question 15 of 20

Most jackknifes happen because:

Drive wheels skid during braking on slippery surfaces
Brakes work too well
The road is dry
Cargo is too light

Correct. Loss of traction on the tractor drive axles during braking — typically on slick surfaces or with overly aggressive braking — causes a jackknife.

Question 16 of 20

When making a right turn at an intersection in a tractor-trailer:

Swing to the left first to make room for the right turn
Make the turn from the right lane and swing wide as needed at the end of the turn
Make the turn at high speed
Stay in the left lane through the turn

Correct. Make the turn from the right lane. If you must swing wide, do so as you complete the turn, never before — swinging left first invites a vehicle to pass on your right.

Question 17 of 20

Combination vehicles are usually:

Easier to drive than single trucks
Harder to drive than single trucks because of length, weight, and the unique handling of articulated vehicles
The same as single trucks
Faster than single trucks

Correct. Combination vehicles (tractor-trailer rigs) are heavier, longer, and articulate at the fifth wheel — all making them more demanding than single-unit trucks.

Question 18 of 20

Off-tracking refers to:

Trailer brakes overheating
Trailer wheels following a tighter path than the tractor wheels in turns
The trailer pulling left
Tires losing tread

Correct. Off-tracking is the tendency for trailer wheels to follow a smaller-radius path than the tractor wheels through a turn, more pronounced with longer wheelbases.

Question 19 of 20

When uncoupling, you should lower the landing gear:

After releasing the jaws
Before releasing the jaws so the trailer is supported when you pull away
Halfway
Not at all

Correct. Lower the landing gear and snug it against the ground before releasing the fifth-wheel jaws so the trailer doesn't drop when you pull away.

Question 20 of 20

The "rearward amplification" effect:

Is greatest in the lead trailer
Is greatest in the rear-most trailer of doubles or triples
Does not exist
Is the same in every trailer

Correct. Rearward amplification — the crack-the-whip effect — is most severe in the rear trailer of a multi-trailer combination.

About the Montana Combination Vehicles exam

Most states administer 20 Combination Vehicles questions and require 80% to pass. The exam emphasizes the unique handling of articulated vehicles: how trailers track behind the tractor, how to prevent rollover, how to manage rearward amplification with multi-trailer combinations, and the correct sequence to couple and uncouple.

The Montana Motor Vehicle Division follows the federal CDL standards established by FMCSA. To earn the Combination Vehicles credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Combination Vehicles question bank or browse all Montana CDL practice tests.