Minnesota Hazmat CDL Practice Test

This is a free 20-question practice test for the Hazmat portion of the Minnesota Commercial Driver's License knowledge exam. Questions are pulled from a pool of 68 drawn from the AAMVA CDL Manual, which is the source document the Minnesota Driver and Vehicle Services uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Minnesota.

Question 1 of 20

Bulk packaging of certain corrosives requires:

No special markings
Display of the proper shipping name on each side and the four-digit ID number on each side and end
Only one placard
Painted red

Correct. Bulk packaging of corrosives, like other hazmat, requires shipping name on the sides and ID-number marking on each side and end.

Question 2 of 20

How many hazard classes are there?

Three
Five
Nine
Twelve

Correct. There are nine hazard classes: 1 explosives, 2 gases, 3 flammable liquids, 4 flammable solids, 5 oxidizers and organic peroxides, 6 toxic and infectious, 7 radioactive, 8 corrosive, 9 miscellaneous.

Question 3 of 20

When loading hazmat that requires segregation, the driver must:

Refuse to mix incompatible materials in the same vehicle, per the segregation table
Mix them anyway
Load whatever fits
Stack on top

Correct. The segregation table in 49 CFR §177.848 lists which classes cannot be loaded together. Refusing improperly mixed loads is the driver's responsibility.

Question 4 of 20

The 24-hour emergency response phone number on the shipping paper:

Is optional
Must be provided by the shipper and monitored 24 hours per day
Is the driver's personal phone
Is for billing

Correct. The 24-hour emergency contact must be a person knowledgeable about the materials, available 24/7. Many shippers contract CHEMTREC or similar.

Question 5 of 20

When in the cab with the engine running, the hazmat shipping paper must be:

In the trailer
Within the driver's reach — clipped on the driver's door clip or on the driver's seat
In the glove compartment
In the trunk

Correct. When in the seat with the engine running, keep shipping papers within reach (driver-side door clip or on the seat). When out of the vehicle, leave on the seat or in the door pouch.

Question 6 of 20

Hazardous materials are products that:

Are heavier than normal cargo
Pose a risk to health, safety, or property during transportation
Can only be hauled at night
Require a special trailer color

Correct. Hazardous materials (hazmat) are products that pose a risk to health, safety, or property during transportation. Hazmat regulations are codified in 49 CFR.

Question 7 of 20

After a hazmat incident, the driver should:

Notify the carrier and complete required reports
Drive home
Wait until the next trip to report
Throw away the shipping paper

Correct. Notify the carrier immediately. Federal incident reports may be required to PHMSA, depending on severity. Retain the shipping paper.

Question 8 of 20

The Emergency Response Guidebook (ERG) is used to:

Plan routes
Look up the four-digit hazmat ID number to find emergency response procedures
Calculate fuel cost
Find truck stops

Correct. The ERG cross-references the four-digit ID number from the placard or shipping paper to a guide page with isolation distance, response procedures, and first aid.

Question 9 of 20

A "DANGEROUS" placard may be used:

Instead of multiple Table 2 placards when 1,001+ lbs of two or more Table 2 materials are loaded
For any cargo
For non-hazmat
For hazmat below 100 lbs

Correct. When more than two Table 2 materials are aboard with combined weight over 1,001 lbs (none over 2,205 lbs at one stop), a single DANGEROUS placard may substitute.

Question 10 of 20

Placards must be displayed on:

One side
Two sides
Three sides
All four sides of the vehicle

Correct. Placards are displayed on all four sides of the vehicle — front, back, and both sides.

Question 11 of 20

Electrical equipment in cargo areas of vehicles transporting Class 3 (flammable) liquids must be:

Disconnected
Spark-free or explosion-proof to prevent ignition
Painted red
Made of plastic

Correct. Wiring and electrical fittings in flammable-liquid loading areas must be designed to prevent ignition — spark-free, sealed, or explosion-proof.

Question 12 of 20

Who is responsible for proper hazmat packaging and labeling?

The shipper
The driver
The carrier
The consignee

Correct. The shipper packages, labels, and certifies the materials. The carrier and driver verify and refuse non-compliant shipments.

Question 13 of 20

When tarping hazmat cargo, you must:

Cover the placards
Leave placards visible at all times
Tarp only at night
Use only red tarps

Correct. Placards must remain visible. Tarps and decorations may not block them.

Question 14 of 20

Hazard Class 3 is:

Flammable liquids
Explosives
Toxic substances
Radioactive

Correct. Class 3 is flammable liquids — gasoline, diesel, ethanol, alcohols, etc.

Question 15 of 20

Class 7 (Radioactive) materials require:

Special placards depending on the radiation level (I, II, or III), maintaining a Transport Index, and limits on aggregate radioactivity in a vehicle
No special handling
Only one placard
No documentation

Correct. Class 7 materials use Roman-numeral category labels (RADIOACTIVE I, II, III), placarded based on aggregate Transport Index, and have specific transport limits.

Question 16 of 20

Inhalation hazard placards (Division 6.1 PIH or Division 2.3) require:

Smaller placards
Subsidiary "INHALATION HAZARD" placards in addition to the primary placard
No placards
Only one placard

Correct. PIH (Poison Inhalation Hazard) materials require a primary hazard-class placard plus an "INHALATION HAZARD" subsidiary placard.

Question 17 of 20

Subsidiary risk labels on a package indicate:

Additional hazards beyond the primary hazard
Just decoration
The price
The weight

Correct. Some materials have multiple hazards. The primary hazard is shown on the top-class label; subsidiary risks (e.g., toxic AND flammable) are shown on additional labels.

Question 18 of 20

A hazmat driver must complete which special training?

General awareness, function-specific, safety, security awareness, and in-depth security if a security plan is required
Forklift training
Basic first aid only
Defensive driving only

Correct. PHMSA requires general awareness, function-specific, safety, security awareness, and in-depth security training (when a security plan applies). Carriers document and re-train every three years.

Question 19 of 20

A driver of a hazmat-loaded vehicle must check the tires:

Once before the trip
At the start of the trip and every time the vehicle is parked
Only at fueling
Never

Correct. Hazmat drivers must check tires at the beginning and again each time the vehicle is parked. A flat or smoking tire must be addressed before continuing.

Question 20 of 20

The Hazmat (H) endorsement requires:

Only a knowledge test
A knowledge test plus a TSA Threat Assessment background check
Just a fee
A skills test only

Correct. Hazmat applicants pass a knowledge test and complete the TSA Threat Assessment (HME), which involves fingerprints and an FBI background check.

About the Minnesota Hazmat exam

Most states administer 30 Hazmat questions and require 80% to pass. The exam covers hazard classes, the shipping paper, placards and labels, loading and unloading, driving and parking rules, emergency response, and the Emergency Response Guidebook (ERG).

The Minnesota Driver and Vehicle Services follows the federal CDL standards established by FMCSA. To earn the Hazmat credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Hazmat question bank or browse all Minnesota CDL practice tests.