Michigan Doubles/Triples CDL Practice Test

This is a free 20-question practice test for the Doubles/Triples portion of the Michigan Commercial Driver's License knowledge exam. Questions are pulled from a pool of 50 drawn from the AAMVA CDL Manual, which is the source document the Michigan Department of State uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Michigan.

Question 1 of 20

When pulling triples, you should:

Make abrupt lane changes
Drive in the right lane and avoid abrupt steering
Drive in the left lane
Drive at top speed

Correct. Stay right, plan lane changes well in advance, signal early, and avoid abrupt steering. Triples crack-the-whip violently.

Question 2 of 20

The "T" endorsement is required to:

Drive any commercial vehicle
Pull two or more trailers
Drive a bus
Haul hazmat

Correct. The T endorsement is required to pull more than one trailer (doubles or triples).

Question 3 of 20

A "set of doubles" typically refers to:

A tractor pulling two trailers
One tractor with one long trailer
Two tractors and a trailer
Two tractors and two trailers

Correct. A "set of doubles" is one tractor pulling two trailers (typically two pups, each about 28 feet long, in LTL operations).

Question 4 of 20

When pulling a heavy lead trailer and a light second trailer, the rig:

Will be more stable than the reverse
Is more likely to roll the rear trailer
Is illegal
Drives the same as either order

Correct. Heaviest in front, lightest in rear. Heavy at the rear amplifies crack-the-whip and rollover risk.

Question 5 of 20

When uncoupling the converter dolly from the lead trailer:

Lower trailer landing gear (if applicable), disconnect air and electrical, remove safety chains, then release pintle hook
Just unhook the chains and pull away
Drive forward fast
Use only the trailer brake

Correct. Standard sequence: support the trailer (landing gear if it is a semi-trailer), disconnect lines, remove chains, release pintle hook.

Question 6 of 20

When parking a doubles rig:

Park where you can pull straight out — back-out is impractical
Back into any spot
Park in the entrance
Block the lane

Correct. Choose pull-through parking. Multi-trailer rigs cannot back any meaningful distance safely.

Question 7 of 20

Safety chains on a converter dolly are required to:

Prevent the dolly from disconnecting if the pintle hook fails
Decorate the rig
Bind cargo
Add weight

Correct. Safety chains catch the dolly if the pintle hook releases or fails — preventing the trailer behind from breaking loose.

Question 8 of 20

Crosswinds are particularly hazardous for:

Empty doubles and triples
Loaded singles
Backing
Slow speeds

Correct. Empty trailers in a multi-trailer rig present a large flat surface to crosswinds — a strong gust can blow the rear trailer over.

Question 9 of 20

A pintle hook is:

The hitch on the rear of a trailer used to tow another trailer or dolly
The kingpin
The fifth wheel
A type of placard

Correct. The pintle hook is the strong rear-mounted hitch that grips the dolly's lunette eye, allowing one trailer to tow another behind it.

Question 10 of 20

Driving doubles or triples on the highway:

Requires gentler steering, longer following distance, and earlier braking
Allows the same maneuvers as a single trailer
Allows higher cornering speeds
Has no special concerns

Correct. Multi-trailer rigs are more sensitive to abrupt steering, take longer to brake, and amplify any movement to the rear. Be gentle and plan ahead.

Question 11 of 20

When inspecting a doubles or triples rig, you should additionally check:

Each pintle hook, each set of safety chains, each converter dolly, each trailer's lights, brake chamber connections, glad-hands, and shut-off valves
Only the lead trailer
Only the tractor
Only the cargo

Correct. Every connection point and every trailer needs inspection — pintle hooks, chains, dollies, lights, brake lines, glad-hands, and air-supply valves.

Question 12 of 20

A converter-dolly fifth wheel must be:

Properly lubricated and have correctly functioning locking jaws
Painted
Wide
Empty

Correct. Inspect for proper lubrication, no excessive wear, and confirm the locking jaws operate correctly. The dolly fifth wheel is just as critical as the tractor's.

Question 13 of 20

When you uncouple a converter dolly, you should:

Disconnect air and electrical, secure or remove safety chains, then release the pintle hook
Just yank it off
Drive forward fast
Use only the trailer brake

Correct. Park level, disconnect air and electric, lower trailer landing gear if applicable, remove safety chains, then release the pintle hook to free the dolly.

Question 14 of 20

Before connecting a converter dolly, you should:

Inspect tires, brakes, fifth-wheel jaws, and overall condition
Skip inspection
Only check the tires
Only check the lights

Correct. Pre-trip the dolly: tires, brake adjustment, fifth-wheel jaws (open and clean), pintle hook, electrical receptacle, lights.

Question 15 of 20

Air pressure on a triple-trailer rig takes:

Less time to reach the rear trailer than on a single
Significantly more time to reach the rear trailer's brake chambers
The same time
No air pressure is needed

Correct. Each additional trailer adds line length. Brake response at the rear trailer of a triple is noticeably delayed — brake earlier.

Question 16 of 20

Glad-hand shut-off valves at the rear of trailers (for connecting to a following trailer) must be:

Open at the rear of the rear-most trailer
Open at the rear of any trailer that has another trailer behind it; closed at the rear of the last trailer
Always closed
Always open

Correct. Open the shut-off valves where the next trailer is connected; close them at the rear of the last trailer to prevent air loss.

Question 17 of 20

When you encounter a breakaway in your doubles (a trailer separates):

Maintain control of the tractor and lead trailer, brake gently to a controlled stop, set warning devices, and contact dispatch
Brake hard
Speed up
Swerve sharply

Correct. Maintain control of what remains, brake gently and progressively, secure the area with warning devices, contact dispatch.

Question 18 of 20

Doubles and triples should not be driven:

On slippery roads at normal speed
On dry, straight highways
In any conditions
Only at low speed

Correct. On slippery roads, multi-trailer rigs lose stability quickly. Reduce speed substantially and increase following distance.

Question 19 of 20

When traveling on bridges with weight or length limits:

Verify the rig's overall length and weight comply with posted limits
Ignore signs
Drive faster
Honk the horn

Correct. Multi-trailer rigs may exceed length or weight limits on certain bridges. Plan routes to comply with posted limits.

Question 20 of 20

A tractor pulling doubles cannot brake as quickly as a tractor pulling a single trailer because:

Doubles are heavier and brake response is delayed in longer air lines
Doubles are lighter
Brakes are bigger
Tractors brake better with doubles

Correct. Greater weight and longer air lines mean longer braking distance. Plan stopping distance with extra margin.

About the Michigan Doubles/Triples exam

Most states administer 20 Doubles/Triples questions and require 80% to pass. The exam emphasizes coupling and uncoupling the converter dolly, rearward amplification (the "crack-the-whip" effect), and the unique inspection and handling demands of multi-trailer rigs.

The Michigan Department of State follows the federal CDL standards established by FMCSA. To earn the Doubles/Triples credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Doubles/Triples question bank or browse all Michigan CDL practice tests.