Maine Doubles/Triples CDL Practice Test

This is a free 20-question practice test for the Doubles/Triples portion of the Maine Commercial Driver's License knowledge exam. Questions are pulled from a pool of 50 drawn from the AAMVA CDL Manual, which is the source document the Maine Bureau of Motor Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Maine.

Question 1 of 20

A converter dolly is:

A small hand truck
A set of axles with a fifth wheel that converts a semi-trailer into a full trailer for use in doubles/triples
A trailer-loading device
A type of brake

Correct. A converter dolly has a small frame, axle(s), and a fifth wheel mounted on top — it transforms a semi-trailer into a full trailer behind another trailer.

Question 2 of 20

When pulling triples, you should:

Make abrupt lane changes
Drive in the right lane and avoid abrupt steering
Drive in the left lane
Drive at top speed

Correct. Stay right, plan lane changes well in advance, signal early, and avoid abrupt steering. Triples crack-the-whip violently.

Question 3 of 20

When traveling on bridges with weight or length limits:

Verify the rig's overall length and weight comply with posted limits
Ignore signs
Drive faster
Honk the horn

Correct. Multi-trailer rigs may exceed length or weight limits on certain bridges. Plan routes to comply with posted limits.

Question 4 of 20

Glad-hand shut-off valves at the rear of trailers (for connecting to a following trailer) must be:

Open at the rear of the rear-most trailer
Open at the rear of any trailer that has another trailer behind it; closed at the rear of the last trailer
Always closed
Always open

Correct. Open the shut-off valves where the next trailer is connected; close them at the rear of the last trailer to prevent air loss.

Question 5 of 20

When inspecting a doubles or triples rig, you should additionally check:

Each pintle hook, each set of safety chains, each converter dolly, each trailer's lights, brake chamber connections, glad-hands, and shut-off valves
Only the lead trailer
Only the tractor
Only the cargo

Correct. Every connection point and every trailer needs inspection — pintle hooks, chains, dollies, lights, brake lines, glad-hands, and air-supply valves.

Question 6 of 20

When making a lane change in a doubles rig, you should:

Signal early, check mirrors, change lanes gradually
Snap the wheel
Use only the trailer hand valve
Skip the signal

Correct. Early signal, mirror check, gradual lane change. Quick lane changes amplify into the rear trailer.

Question 7 of 20

When adjusting the order of trailers in a multi-trailer rig:

Place the heaviest immediately behind the tractor and progressively lighter to the rear
Place the heaviest at the rear
Order does not matter
Order is alphabetical

Correct. Heaviest first, lightest last. This minimizes rearward amplification and rollover risk in the rear trailers.

Question 8 of 20

Inspecting safety chains on a converter dolly:

Verify they are correctly crossed and have no broken links, deformations, or wear
Skip the chains
Replace them daily
Verify color only

Correct. Safety chains should be intact, no broken links or excessive wear, and properly crossed under the pintle for support.

Question 9 of 20

When you couple a converter dolly to a lead trailer, you should:

Close the lead trailer's shut-off valves only after the second trailer is fully connected and air flows
Open all valves at the start
Skip air supply
Close everything before connecting

Correct. Manage shut-off valves so air supply is restored to the rear trailer in proper sequence; verify with brake checks.

Question 10 of 20

A pintle hook is:

The hitch on the rear of a trailer used to tow another trailer or dolly
The kingpin
The fifth wheel
A type of placard

Correct. The pintle hook is the strong rear-mounted hitch that grips the dolly's lunette eye, allowing one trailer to tow another behind it.

Question 11 of 20

During a pre-trip on doubles, the trailer-supply line:

Should be open from tractor to rear-most trailer
Should be open at the front but closed at the rear-most trailer
Should be closed everywhere
Should always be disconnected

Correct. The supply line carries air from tractor through every trailer; verify open valves at every coupled connection and a closed valve at the rear of the rear-most trailer.

Question 12 of 20

Coupling order for a set of doubles starts with:

Coupling the lead (front) trailer to the tractor first, charging air, then attaching the converter dolly to the rear of the lead trailer, then attaching the second trailer
Coupling the rear trailer first
Coupling the dolly first
It does not matter

Correct. Standard order: tractor + lead trailer first, charge air, then attach converter dolly behind lead trailer, then second trailer to dolly.

Question 13 of 20

You discover a flat tire on the rear trailer of a triple. You should:

Continue driving
Pull off safely, set warning devices, and have the tire repaired or replaced before continuing
Drive only at night
Drive faster to balance

Correct. A flat tire affects rig stability and brake load. Pull off safely, use warning devices, and address the tire.

Question 14 of 20

The "T" endorsement is required to:

Drive any commercial vehicle
Pull two or more trailers
Drive a bus
Haul hazmat

Correct. The T endorsement is required to pull more than one trailer (doubles or triples).

Question 15 of 20

When backing a doubles or triples combination:

Avoid it whenever possible — multi-trailer rigs cannot be backed any meaningful distance safely
Back at full speed
Back without a helper
Use only the trailer brake

Correct. Doubles and triples cannot be backed safely beyond a few feet — joints flex unpredictably. Plan your route and parking to avoid backing.

Question 16 of 20

A safe practice when starting from a stop with doubles:

Accelerate gently to avoid breakaway sway in the second trailer
Floor the accelerator
Use only the trailer hand valve
Skip first gear

Correct. Sudden acceleration can cause the rear trailer to sway. Start gently in low gear.

Question 17 of 20

An empty rear trailer on a multi-trailer rig:

Is more likely to roll over in evasive steering than a loaded one
Is always stable
Cannot roll over
Has no effect

Correct. Lighter trailer = more vulnerable to crack-the-whip and crosswinds. Empty rear trailers in multi-trailer rigs roll easily.

Question 18 of 20

Drivers should always couple the heaviest trailer:

Behind the tractor (in the front position)
At the rear
In the middle
It does not matter

Correct. Heaviest trailer goes directly behind the tractor; lightest goes at the rear. This minimizes rearward amplification and rollover risk.

Question 19 of 20

When coupling the second trailer to the converter dolly:

Position the dolly in front of the second trailer, lower trailer landing gear if necessary, lock the dolly to the lead trailer's pintle hook with safety chains, then back the second trailer onto the fifth wheel
Just push them together
Use the trailer hand valve
Drive past it fast

Correct. Position dolly, secure to lead-trailer pintle, then back second trailer over the fifth wheel and lock as a normal coupling.

Question 20 of 20

A converter-dolly fifth wheel must be:

Properly lubricated and have correctly functioning locking jaws
Painted
Wide
Empty

Correct. Inspect for proper lubrication, no excessive wear, and confirm the locking jaws operate correctly. The dolly fifth wheel is just as critical as the tractor's.

About the Maine Doubles/Triples exam

Most states administer 20 Doubles/Triples questions and require 80% to pass. The exam emphasizes coupling and uncoupling the converter dolly, rearward amplification (the "crack-the-whip" effect), and the unique inspection and handling demands of multi-trailer rigs.

The Maine Bureau of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Doubles/Triples credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Doubles/Triples question bank or browse all Maine CDL practice tests.