Louisiana Doubles/Triples CDL Practice Test

This is a free 20-question practice test for the Doubles/Triples portion of the Louisiana Commercial Driver's License knowledge exam. Questions are pulled from a pool of 50 drawn from the AAMVA CDL Manual, which is the source document the Louisiana Office of Motor Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Louisiana.

Question 1 of 20

Drivers should always couple the heaviest trailer:

Behind the tractor (in the front position)
At the rear
In the middle
It does not matter

Correct. Heaviest trailer goes directly behind the tractor; lightest goes at the rear. This minimizes rearward amplification and rollover risk.

Question 2 of 20

An empty rear trailer on a multi-trailer rig:

Is more likely to roll over in evasive steering than a loaded one
Is always stable
Cannot roll over
Has no effect

Correct. Lighter trailer = more vulnerable to crack-the-whip and crosswinds. Empty rear trailers in multi-trailer rigs roll easily.

Question 3 of 20

Crosswinds are particularly hazardous for:

Empty doubles and triples
Loaded singles
Backing
Slow speeds

Correct. Empty trailers in a multi-trailer rig present a large flat surface to crosswinds — a strong gust can blow the rear trailer over.

Question 4 of 20

When adjusting the order of trailers in a multi-trailer rig:

Place the heaviest immediately behind the tractor and progressively lighter to the rear
Place the heaviest at the rear
Order does not matter
Order is alphabetical

Correct. Heaviest first, lightest last. This minimizes rearward amplification and rollover risk in the rear trailers.

Question 5 of 20

Driving doubles or triples on the highway:

Requires gentler steering, longer following distance, and earlier braking
Allows the same maneuvers as a single trailer
Allows higher cornering speeds
Has no special concerns

Correct. Multi-trailer rigs are more sensitive to abrupt steering, take longer to brake, and amplify any movement to the rear. Be gentle and plan ahead.

Question 6 of 20

Triples are restricted in many states. You should:

Drive triples anywhere
Verify state-by-state legality before crossing into a state
Use a special placard
Avoid driving in cities

Correct. Many states restrict triples to specific routes (turnpikes, designated corridors). Verify legality and route before crossing into a state.

Question 7 of 20

Doubles and triples should not be driven:

On slippery roads at normal speed
On dry, straight highways
In any conditions
Only at low speed

Correct. On slippery roads, multi-trailer rigs lose stability quickly. Reduce speed substantially and increase following distance.

Question 8 of 20

Inspecting safety chains on a converter dolly:

Verify they are correctly crossed and have no broken links, deformations, or wear
Skip the chains
Replace them daily
Verify color only

Correct. Safety chains should be intact, no broken links or excessive wear, and properly crossed under the pintle for support.

Question 9 of 20

A "doubles" combination uses a tractor plus:

Two trailers connected by a dolly
One trailer
Three trailers
No trailers

Correct. Doubles = tractor + lead semi-trailer + converter dolly + second semi-trailer (which becomes a full trailer once on the dolly).

Question 10 of 20

Crosswinds may cause the rear trailer of a doubles to:

Sway dangerously, especially when empty
Brake automatically
Steer itself
Have no effect

Correct. Empty trailers act as sails. Strong crosswinds can sway or even tip an empty rear trailer. Reduce speed in high winds.

Question 11 of 20

When parking a doubles rig:

Park where you can pull straight out — back-out is impractical
Back into any spot
Park in the entrance
Block the lane

Correct. Choose pull-through parking. Multi-trailer rigs cannot back any meaningful distance safely.

Question 12 of 20

A doubles rig is more likely to roll over than a single because:

The center of gravity is higher
The crack-the-whip effect amplifies steering input at the rear, where rollover threshold is lower
It is heavier
It is shorter

Correct. Multi-trailer rollover comes from rearward amplification — even modest steering input at the tractor becomes a violent swing at the rear trailer.

Question 13 of 20

When you encounter a breakaway in your doubles (a trailer separates):

Maintain control of the tractor and lead trailer, brake gently to a controlled stop, set warning devices, and contact dispatch
Brake hard
Speed up
Swerve sharply

Correct. Maintain control of what remains, brake gently and progressively, secure the area with warning devices, contact dispatch.

Question 14 of 20

Glad-hand shut-off valves at the rear of trailers (for connecting to a following trailer) must be:

Open at the rear of the rear-most trailer
Open at the rear of any trailer that has another trailer behind it; closed at the rear of the last trailer
Always closed
Always open

Correct. Open the shut-off valves where the next trailer is connected; close them at the rear of the last trailer to prevent air loss.

Question 15 of 20

When making a lane change in a doubles rig, you should:

Signal early, check mirrors, change lanes gradually
Snap the wheel
Use only the trailer hand valve
Skip the signal

Correct. Early signal, mirror check, gradual lane change. Quick lane changes amplify into the rear trailer.

Question 16 of 20

Coupling order for a set of doubles starts with:

Coupling the lead (front) trailer to the tractor first, charging air, then attaching the converter dolly to the rear of the lead trailer, then attaching the second trailer
Coupling the rear trailer first
Coupling the dolly first
It does not matter

Correct. Standard order: tractor + lead trailer first, charge air, then attach converter dolly behind lead trailer, then second trailer to dolly.

Question 17 of 20

When inspecting a doubles rig, the lights on the rear of the rear-most trailer must:

Be visible, working, and not blocked by the lead trailer
Only the lead trailer's lights matter
Be off
Not be checked

Correct. Brake, turn, and marker lights at the rear of the rearmost trailer must be working and visible — that is what following traffic sees.

Question 18 of 20

When pulling a single trailer and trying to figure out if you should add a doubles endorsement:

You only need T if you actually pull more than one trailer
T is required for any commercial driving
T is required only for tankers
T is required for any class A driver

Correct. The T endorsement is required only when you actually operate doubles or triples. Single-trailer operations do not require it.

Question 19 of 20

The "T" endorsement is required to:

Drive any commercial vehicle
Pull two or more trailers
Drive a bus
Haul hazmat

Correct. The T endorsement is required to pull more than one trailer (doubles or triples).

Question 20 of 20

A converter dolly is:

A small hand truck
A set of axles with a fifth wheel that converts a semi-trailer into a full trailer for use in doubles/triples
A trailer-loading device
A type of brake

Correct. A converter dolly has a small frame, axle(s), and a fifth wheel mounted on top — it transforms a semi-trailer into a full trailer behind another trailer.

About the Louisiana Doubles/Triples exam

Most states administer 20 Doubles/Triples questions and require 80% to pass. The exam emphasizes coupling and uncoupling the converter dolly, rearward amplification (the "crack-the-whip" effect), and the unique inspection and handling demands of multi-trailer rigs.

The Louisiana Office of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Doubles/Triples credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Doubles/Triples question bank or browse all Louisiana CDL practice tests.