Louisiana Air Brakes CDL Practice Test

This is a free 20-question practice test for the Air Brakes portion of the Louisiana Commercial Driver's License knowledge exam. Questions are pulled from a pool of 71 drawn from the AAMVA CDL Manual, which is the source document the Louisiana Office of Motor Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Louisiana.

Question 1 of 20

Total stopping distance with air brakes equals:

Perception distance + reaction distance + brake-lag distance + effective braking distance
Reaction distance only
Brake-lag distance only
Perception distance + braking distance

Correct. Add brake-lag distance to the standard perception + reaction + braking distance for any vehicle with air brakes.

Question 2 of 20

The spring brakes:

Are held off by air pressure and apply automatically when pressure drops
Are activated only by the foot valve
Are activated only by the trailer hand valve
Are not used in modern trucks

Correct. Spring brakes use heavy springs that apply the brake when air pressure is released or drops below 20-45 psi — they serve as both parking and emergency brake.

Question 3 of 20

The S-cam:

Is a type of fuel pump
Forces the brake shoes against the drum to provide braking action
Adjusts the slack adjuster
Is the parking-brake control

Correct. When the foot valve is pressed, air pushes the brake-chamber pushrod, which moves the slack adjuster, which rotates the S-cam shaft, forcing the shoes against the drum.

Question 4 of 20

When you make a normal stop with air brakes, you should:

Push the brake pedal down hard
Apply firm steady pressure to slow you smoothly
Pump the brakes
Use only the trailer brake

Correct. For normal stops, apply steady firm pressure on the foot valve and adjust to maintain a smooth stop.

Question 5 of 20

You hear a steady "ssss" sound while parked with the engine off. This is most likely:

Normal venting
An air leak that needs immediate attention
The compressor running
Trailer brakes releasing

Correct. A steady hiss with the engine off indicates an air leak — find and repair before driving.

Question 6 of 20

The trailer air-supply control:

Is a yellow diamond knob
Is a red eight-sided (octagonal) knob
Is a green knob
Is the same knob as the parking brake

Correct. The trailer air-supply (tractor protection) is a red eight-sided knob. Push in to supply air to the trailer; pull out to shut off air.

Question 7 of 20

On a vehicle with ABS, in an emergency stop you should:

Pump the brakes
Apply the brakes the way you always would and steer where you need to go
Apply the parking brake
Coast

Correct. ABS lets you brake hard and continue steering. Brake firmly and avoid pumping — pumping defeats the system.

Question 8 of 20

A long downgrade requires:

Riding the brakes the whole way
Selecting a low gear before starting down and using intermittent firm brake applications
Coasting in neutral
Using the engine brake only

Correct. Pick a low gear before starting down. Use the brakes in firm, intermittent applications: brake to 5 mph below safe speed, release, repeat.

Question 9 of 20

When releasing brakes after a hard stop, you should:

Continue holding the brakes
Release smoothly to allow air to refill the tanks
Pump the brakes
Apply the parking brake immediately

Correct. Release the brakes smoothly. Air tanks refill while you drive; allow the compressor to recharge the system before the next braking event.

Question 10 of 20

A low-air-pressure warning device must come on at or before:

20 psi
40 psi
60 psi
80 psi

Correct. A federal-mandated low-air-pressure warning (light, buzzer, or wig-wag) must activate at or before 60 psi.

Question 11 of 20

For a single vehicle with engine off and brakes applied, the maximum allowable air-loss rate is:

1 psi/min
2 psi/min
3 psi/min
4 psi/min

Correct. A single vehicle is allowed no more than 3 psi/min with brakes fully applied.

Question 12 of 20

In a dual air-brake system, you should let the air pressure build to at least what level before driving?

60 psi
80 psi
100 psi
125 psi

Correct. Wait until the system pressure is at least 100 psi before driving in a dual air-brake system.

Question 13 of 20

In a dual air-brake system, the time required for air pressure to build from 85 to 100 psi should be no more than:

15 seconds
30 seconds
45 seconds
120 seconds

Correct. In dual air-brake systems, air should build from 85 to 100 psi within 45 seconds at engine governed RPM.

Question 14 of 20

Brake fade is the result of:

Cold brakes
Worn linings only
Heat from continuous use, which reduces braking effectiveness
Air leaks

Correct. Brake fade comes from heat. Manage downgrade speed by gear selection plus intermittent firm brake use, not continuous light pressure.

Question 15 of 20

You should perform a static air-leakage test by:

Driving and watching the gauge
With the engine off, brakes released, watching air pressure for one minute
With the engine running at high RPM
By tapping the air tank with a wrench

Correct. Engine off, brakes released, fully charged system: watch for air loss over one minute. Then apply brakes and check again.

Question 16 of 20

When the spring brakes apply automatically as air pressure drops, this typically happens between:

100 and 120 psi
60 and 80 psi
20 and 45 psi
5 and 10 psi

Correct. Spring brakes will fully apply somewhere between 20 and 45 psi as system pressure drops, depending on the vehicle.

Question 17 of 20

In a fully charged dual air-brake system at idle, you should test the low-pressure warning by:

Letting the air bleed down with the engine off and brakes off, fanning the brakes if needed; warning should activate at or before 60 psi
Holding the foot valve down for one minute
Removing the alternator belt
Disconnecting the compressor

Correct. Engine off, fan the brake pedal to bleed pressure. The low-pressure warning device should activate before pressure drops below 60 psi.

Question 18 of 20

Air brakes take longer to work than hydraulic brakes because:

Air takes longer to flow than fluid
Air-brake lines are longer than hydraulic lines and have more components
Drivers wait longer to brake
Air brakes are simpler

Correct. Brake-lag in air systems comes from the time air takes to travel through lines and reach all the brake chambers — typically 0.4 seconds added to perception/reaction time.

Question 19 of 20

When checking the brakes on a downgrade, you should:

Use the air-pressure gauge to monitor brake-system pressure for excessive use
Pump the pedal
Drive faster
Ignore the gauge

Correct. Watch the air-pressure gauge. If pressure drops faster than the compressor can recover, brakes are being used too aggressively for the gear selection.

Question 20 of 20

The brake-system warning light or buzzer is designed to alert you when:

The brakes are working
Air pressure has dropped below the level needed to brake safely
Brake fluid is low
You haven't serviced the brakes recently

Correct. The brake-system warning device alerts you to dangerous low air pressure — typically activating at or before 60 psi.

About the Louisiana Air Brakes exam

States typically administer 25 Air Brakes questions and require 80% to pass. Questions cover air-brake system parts, dual systems, supply pressure, brake-system warning, slack adjusters, the parking brake, the spring brake, the pre-trip air-system check, and the proper way to perform a leakage-rate test.

The Louisiana Office of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Air Brakes credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Air Brakes question bank or browse all Louisiana CDL practice tests.