Kansas Doubles/Triples CDL Practice Test

This is a free 20-question practice test for the Doubles/Triples portion of the Kansas Commercial Driver's License knowledge exam. Questions are pulled from a pool of 50 drawn from the AAMVA CDL Manual, which is the source document the Kansas Division of Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Kansas.
Question 1 of 20
The "T" endorsement is required to:
Correct. The T endorsement is required to pull more than one trailer (doubles or triples).
Question 2 of 20
Before connecting a converter dolly, you should:
Correct. Pre-trip the dolly: tires, brake adjustment, fifth-wheel jaws (open and clean), pintle hook, electrical receptacle, lights.
Question 3 of 20
Drivers should always couple the heaviest trailer:
Correct. Heaviest trailer goes directly behind the tractor; lightest goes at the rear. This minimizes rearward amplification and rollover risk.
Question 4 of 20
In a multi-trailer combination, the most violent movement during evasive maneuvers happens at:
Correct. Rearward amplification (crack-the-whip effect) is greatest at the rear-most trailer. The last trailer in a triple can be thrown sideways with much greater force than the tractor.
Question 5 of 20
Glad-hand shut-off valves at the rear of trailers (for connecting to a following trailer) must be:
Correct. Open the shut-off valves where the next trailer is connected; close them at the rear of the last trailer to prevent air loss.
Question 6 of 20
When pulling triples, you should:
Correct. Stay right, plan lane changes well in advance, signal early, and avoid abrupt steering. Triples crack-the-whip violently.
Question 7 of 20
A converter dolly is:
Correct. A converter dolly has a small frame, axle(s), and a fifth wheel mounted on top — it transforms a semi-trailer into a full trailer behind another trailer.
Question 8 of 20
When coupling the second trailer to the converter dolly:
Correct. Position dolly, secure to lead-trailer pintle, then back second trailer over the fifth wheel and lock as a normal coupling.
Question 9 of 20
You discover a flat tire on the rear trailer of a triple. You should:
Correct. A flat tire affects rig stability and brake load. Pull off safely, use warning devices, and address the tire.
Question 10 of 20
Driving doubles or triples on the highway:
Correct. Multi-trailer rigs are more sensitive to abrupt steering, take longer to brake, and amplify any movement to the rear. Be gentle and plan ahead.
Question 11 of 20
Inspecting safety chains on a converter dolly:
Correct. Safety chains should be intact, no broken links or excessive wear, and properly crossed under the pintle for support.
Question 12 of 20
When uncoupling the converter dolly from the lead trailer:
Correct. Standard sequence: support the trailer (landing gear if it is a semi-trailer), disconnect lines, remove chains, release pintle hook.
Question 13 of 20
When you uncouple a converter dolly, you should:
Correct. Park level, disconnect air and electric, lower trailer landing gear if applicable, remove safety chains, then release the pintle hook to free the dolly.
Question 14 of 20
A "set of doubles" typically refers to:
Correct. A "set of doubles" is one tractor pulling two trailers (typically two pups, each about 28 feet long, in LTL operations).
Question 15 of 20
Triples are restricted in many states. You should:
Correct. Many states restrict triples to specific routes (turnpikes, designated corridors). Verify legality and route before crossing into a state.
Question 16 of 20
During a pre-trip on doubles, the trailer-supply line:
Correct. The supply line carries air from tractor through every trailer; verify open valves at every coupled connection and a closed valve at the rear of the rear-most trailer.
Question 17 of 20
When inspecting a converter dolly, the pintle hook must:
Correct. The pintle hook must close fully around the lunette eye, with no excessive wear or cracks. Add safety chains as backup.
Question 18 of 20
When pulling a heavy lead trailer and a light second trailer, the rig:
Correct. Heaviest in front, lightest in rear. Heavy at the rear amplifies crack-the-whip and rollover risk.
Question 19 of 20
You should never:
Correct. Sudden steering with triples can cause the rear trailer to roll. Avoid abrupt steering and plan lane changes far in advance.
Question 20 of 20
A "set of triples" typically refers to:
Correct. A set of triples is one tractor pulling three trailers — usually allowed only on specific designated routes.

About the Kansas Doubles/Triples exam

Most states administer 20 Doubles/Triples questions and require 80% to pass. The exam emphasizes coupling and uncoupling the converter dolly, rearward amplification (the "crack-the-whip" effect), and the unique inspection and handling demands of multi-trailer rigs.

The Kansas Division of Vehicles follows the federal CDL standards established by FMCSA. To earn the Doubles/Triples credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Doubles/Triples question bank or browse all Kansas CDL practice tests.