Indiana Doubles/Triples CDL Practice Test
This is a free 20-question practice test for the Doubles/Triples portion of the Indiana Commercial Driver's License knowledge exam. Questions are pulled from a pool of 50 drawn from the AAMVA CDL Manual, which is the source document the Indiana Bureau of Motor Vehicles uses to write its actual exam.
How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Indiana.
Question 1 of 20
Drivers should always couple the heaviest trailer:
Correct. Heaviest trailer goes directly behind the tractor; lightest goes at the rear. This minimizes rearward amplification and rollover risk.
Question 2 of 20
Driving doubles or triples on the highway:
Correct. Multi-trailer rigs are more sensitive to abrupt steering, take longer to brake, and amplify any movement to the rear. Be gentle and plan ahead.
Question 3 of 20
Air pressure on a triple-trailer rig takes:
Correct. Each additional trailer adds line length. Brake response at the rear trailer of a triple is noticeably delayed — brake earlier.
Question 4 of 20
During a pre-trip on doubles, the trailer-supply line:
Correct. The supply line carries air from tractor through every trailer; verify open valves at every coupled connection and a closed valve at the rear of the rear-most trailer.
Question 5 of 20
Safety chains on a converter dolly are required to:
Correct. Safety chains catch the dolly if the pintle hook releases or fails — preventing the trailer behind from breaking loose.
Question 6 of 20
Inspecting safety chains on a converter dolly:
Correct. Safety chains should be intact, no broken links or excessive wear, and properly crossed under the pintle for support.
Question 7 of 20
A "drive-axle skid" on a doubles rig:
Correct. A drive-axle skid leads to tractor jackknife. With trailers behind, the situation gets worse fast — the rear trailers can swing wildly.
Question 8 of 20
When inspecting a converter dolly, the pintle hook must:
Correct. The pintle hook must close fully around the lunette eye, with no excessive wear or cracks. Add safety chains as backup.
Question 9 of 20
You should never:
Correct. Sudden steering with triples can cause the rear trailer to roll. Avoid abrupt steering and plan lane changes far in advance.
Question 10 of 20
Doubles and triples should not be driven:
Correct. On slippery roads, multi-trailer rigs lose stability quickly. Reduce speed substantially and increase following distance.
Question 11 of 20
A pintle hook is:
Correct. The pintle hook is the strong rear-mounted hitch that grips the dolly's lunette eye, allowing one trailer to tow another behind it.
Question 12 of 20
Crosswinds are particularly hazardous for:
Correct. Empty trailers in a multi-trailer rig present a large flat surface to crosswinds — a strong gust can blow the rear trailer over.
Question 13 of 20
Glad-hand shut-off valves at the rear of trailers (for connecting to a following trailer) must be:
Correct. Open the shut-off valves where the next trailer is connected; close them at the rear of the last trailer to prevent air loss.
Question 14 of 20
When coupling the second trailer to the converter dolly:
Correct. Position dolly, secure to lead-trailer pintle, then back second trailer over the fifth wheel and lock as a normal coupling.
Question 15 of 20
When backing a doubles or triples combination:
Correct. Doubles and triples cannot be backed safely beyond a few feet — joints flex unpredictably. Plan your route and parking to avoid backing.
Question 16 of 20
When pulling a heavy lead trailer and a light second trailer, the rig:
Correct. Heaviest in front, lightest in rear. Heavy at the rear amplifies crack-the-whip and rollover risk.
Question 17 of 20
When adjusting the order of trailers in a multi-trailer rig:
Correct. Heaviest first, lightest last. This minimizes rearward amplification and rollover risk in the rear trailers.
Question 18 of 20
When pulling doubles in a tunnel:
Correct. Tunnel clearance can be tight for long doubles — watch overhead and side clearance, and respect any vehicle-class restrictions.
Question 19 of 20
Triples are restricted in many states. You should:
Correct. Many states restrict triples to specific routes (turnpikes, designated corridors). Verify legality and route before crossing into a state.
Question 20 of 20
Coupling order for a set of doubles starts with:
Correct. Standard order: tractor + lead trailer first, charge air, then attach converter dolly behind lead trailer, then second trailer to dolly.
About the Indiana Doubles/Triples exam
Most states administer 20 Doubles/Triples questions and require 80% to pass. The exam emphasizes coupling and uncoupling the converter dolly, rearward amplification (the "crack-the-whip" effect), and the unique inspection and handling demands of multi-trailer rigs.
The Indiana Bureau of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Doubles/Triples credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.
Want more practice? Try the full Doubles/Triples question bank or browse all Indiana CDL practice tests.