Indiana Air Brakes CDL Practice Test

This is a free 20-question practice test for the Air Brakes portion of the Indiana Commercial Driver's License knowledge exam. Questions are pulled from a pool of 71 drawn from the AAMVA CDL Manual, which is the source document the Indiana Bureau of Motor Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Indiana.

Question 1 of 20

Air storage tanks are used to:

Carry coolant
Hold compressed air for use by the brakes
Store fuel
House the alternator

Correct. Air storage (or "supply") tanks hold compressed air ready for brake application. Trucks have multiple tanks for redundancy.

Question 2 of 20

When should you use the trailer hand valve to slow the rig?

Whenever you want trailer-only braking
Never; using the trailer hand valve alone can cause a trailer skid
Always when going downhill
Only on dry pavement

Correct. Using the trailer hand valve alone applies brakes only at the trailer wheels and can cause the trailer to lock up and skid. Always use the foot valve to brake.

Question 3 of 20

The "brake-system warning device" must come on no later than:

10 psi
30 psi
60 psi
100 psi

Correct. A federal-rule low-air-pressure warning device must activate at or before 60 psi.

Question 4 of 20

Air tanks must be drained because:

They get heavy
Compressor oil and water can collect inside, contaminating the brake system
They expire
It is required after every trip

Correct. Water and compressor oil collect at the bottom of air tanks. They must be drained to keep the system clean and prevent winter freeze-ups.

Question 5 of 20

On a vehicle with ABS, in an emergency stop you should:

Pump the brakes
Apply the brakes the way you always would and steer where you need to go
Apply the parking brake
Coast

Correct. ABS lets you brake hard and continue steering. Brake firmly and avoid pumping — pumping defeats the system.

Question 6 of 20

Slack adjusters need to be checked because:

They wear and require adjustment to maintain braking force
They never need attention
They are decorative
They affect only the parking brake

Correct. Slack adjusters control how far the pushrod must travel to apply the brake. Out-of-adjustment slack adjusters are the leading mechanical cause of out-of-service violations.

Question 7 of 20

The application pressure gauge shows:

The pressure in the storage tanks
How much pressure is being applied to the brakes when you press the foot valve
Tire pressure
Engine oil pressure

Correct. The application gauge (when present) shows brake-application pressure — useful for spotting brake-system problems on long downgrades.

Question 8 of 20

After connecting the trailer air lines, you should:

Drive away
Charge the trailer air system, check that the trailer brakes work, and inspect glad-hand connections
Lock the trailer brakes
Turn off the supply

Correct. Charge the trailer system, then test the trailer brakes by pulling out the trailer-supply knob to make sure they hold the trailer.

Question 9 of 20

You hear a steady "ssss" sound while parked with the engine off. This is most likely:

Normal venting
An air leak that needs immediate attention
The compressor running
Trailer brakes releasing

Correct. A steady hiss with the engine off indicates an air leak — find and repair before driving.

Question 10 of 20

When should you NOT use the parking brakes?

When the vehicle is parked
When the brakes are very hot, such as after a long downgrade — they could damage if applied
At any time
When the engine is off

Correct. Hot brakes can be damaged by the spring brakes contracting against hot drums. Let the brakes cool before parking.

Question 11 of 20

The spring brakes:

Are held off by air pressure and apply automatically when pressure drops
Are activated only by the foot valve
Are activated only by the trailer hand valve
Are not used in modern trucks

Correct. Spring brakes use heavy springs that apply the brake when air pressure is released or drops below 20-45 psi — they serve as both parking and emergency brake.

Question 12 of 20

When the air-pressure protection valve closes during driving (because pressure dropped too low), the trailer:

Continues without effect
Spring brakes apply, and the trailer stops
Loses electrical power
Turns off its lights

Correct. When tractor air pressure falls into the 20-45 psi range, the protection valve closes, cutting trailer air, which causes the trailer spring brakes to apply.

Question 13 of 20

Brake fade is the result of:

Cold brakes
Worn linings only
Heat from continuous use, which reduces braking effectiveness
Air leaks

Correct. Brake fade comes from heat. Manage downgrade speed by gear selection plus intermittent firm brake use, not continuous light pressure.

Question 14 of 20

In a dual air-brake system, you should let the air pressure build to at least what level before driving?

60 psi
80 psi
100 psi
125 psi

Correct. Wait until the system pressure is at least 100 psi before driving in a dual air-brake system.

Question 15 of 20

For a single vehicle (not a combination) with engine off and brakes released, the maximum allowable air-loss rate is:

1 psi/min
2 psi/min
3 psi/min
4 psi/min

Correct. A single vehicle is allowed no more than 2 psi/min of air loss with engine off and brakes released.

Question 16 of 20

Pre-trip air-brake check (Step 1) is to:

Test the parking brake
Test the air leakage rate
Time the air-pressure build-up
Check the slack adjusters

Correct. In the seven-step air-brake check the first step is testing the parking brake — release service brakes, set parking brake, gently try to move the vehicle in low gear.

Question 17 of 20

Modern trucks have ABS that is required on:

Tractors built after March 1, 1998 and trailers built after March 1, 1998
All trucks
Only school buses
Only doubles

Correct. Federal rule: tractors built after March 1, 1997, and trailers and single-unit air-braked vehicles after March 1, 1998, must have ABS.

Question 18 of 20

Stopping distance for a vehicle with air brakes is the sum of:

Perception distance + reaction distance + brake-lag distance + braking distance
Brake-lag only
Reaction time only
Braking distance only

Correct. Air-brake stopping distance is perception + reaction + brake lag + braking — the brake lag is the unique addition.

Question 19 of 20

You should check the air-system pressure build-up time during pre-trip:

Yes — 85 to 100 psi within 45 seconds in dual systems at governed RPM
No, it is not part of pre-trip
Only on cold mornings
Only on triple-trailer rigs

Correct. In dual air-brake systems, the air should build from 85 to 100 psi within 45 seconds with the engine at governed RPM.

Question 20 of 20

Air brakes take longer to work than hydraulic brakes because:

Air takes longer to flow than fluid
Air-brake lines are longer than hydraulic lines and have more components
Drivers wait longer to brake
Air brakes are simpler

Correct. Brake-lag in air systems comes from the time air takes to travel through lines and reach all the brake chambers — typically 0.4 seconds added to perception/reaction time.

About the Indiana Air Brakes exam

States typically administer 25 Air Brakes questions and require 80% to pass. Questions cover air-brake system parts, dual systems, supply pressure, brake-system warning, slack adjusters, the parking brake, the spring brake, the pre-trip air-system check, and the proper way to perform a leakage-rate test.

The Indiana Bureau of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Air Brakes credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Air Brakes question bank or browse all Indiana CDL practice tests.