Illinois Air Brakes CDL Practice Test

This is a free 20-question practice test for the Air Brakes portion of the Illinois Commercial Driver's License knowledge exam. Questions are pulled from a pool of 71 drawn from the AAMVA CDL Manual, which is the source document the Illinois Secretary of State Commercial Driver Licensing uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Illinois.

Question 1 of 20

The parts of an air-brake system include:

Air compressor, governor, air storage tanks, foot valve, and brake chambers
Master cylinder, brake fluid, and calipers
Hydraulic pump, lines, and disc rotors
Vacuum booster and reservoir

Correct. Air-brake systems use a compressor, governor, storage tanks, foot valve, and brake chambers — distinct from hydraulic systems used in cars.

Question 2 of 20

The governor controls:

Engine RPM
When the air compressor pumps air into the air storage tanks
Brake-pedal travel
Trailer hand-valve operation

Correct. The governor cycles the compressor: it cuts the compressor in around 100 psi and cuts it out around 125 psi.

Question 3 of 20

The supply pressure gauges show:

The brake-pedal pressure
The pressure in the air storage tanks
The amount of air being used by the brakes
The trailer brake pressure only

Correct. The supply (primary and secondary) pressure gauges show air pressure available for braking — a critical reading before driving and during operation.

Question 4 of 20

Air tanks must be drained because:

They get heavy
Compressor oil and water can collect inside, contaminating the brake system
They expire
It is required after every trip

Correct. Water and compressor oil collect at the bottom of air tanks. They must be drained to keep the system clean and prevent winter freeze-ups.

Question 5 of 20

Wet brakes:

Improve braking
Cause reduced power, brake pulling, or wheel lockup
Have no effect
Are normal in winter

Correct. After fording water, brakes may be wet. Drive slowly while applying light brake pressure to dry them.

Question 6 of 20

The S-cam:

Is a type of fuel pump
Forces the brake shoes against the drum to provide braking action
Adjusts the slack adjuster
Is the parking-brake control

Correct. When the foot valve is pressed, air pushes the brake-chamber pushrod, which moves the slack adjuster, which rotates the S-cam shaft, forcing the shoes against the drum.

Question 7 of 20

When the spring brakes apply automatically as air pressure drops, this typically happens between:

100 and 120 psi
60 and 80 psi
20 and 45 psi
5 and 10 psi

Correct. Spring brakes will fully apply somewhere between 20 and 45 psi as system pressure drops, depending on the vehicle.

Question 8 of 20

When should you NOT use the parking brakes?

When the vehicle is parked
When the brakes are very hot, such as after a long downgrade — they could damage if applied
At any time
When the engine is off

Correct. Hot brakes can be damaged by the spring brakes contracting against hot drums. Let the brakes cool before parking.

Question 9 of 20

You should drain the air tanks:

Once a month
Once a year
At the end of every working day
Never

Correct. Drain all air tanks at the end of each working day to remove water and compressor oil that has condensed in the tanks.

Question 10 of 20

Manual slack adjusters must be adjusted:

Only by a mechanic at the dealership
By the driver, when needed, following manufacturer specifications
Never
Only at the time of vehicle inspection

Correct. Drivers may adjust manual slack adjusters in compliance with manufacturer specifications. Automatic slack adjusters are now standard but still require periodic checking.

Question 11 of 20

Air-brake adjustment is critical because out-of-adjustment brakes:

Reduce stopping power and can cause failure on long downgrades
Improve fuel economy
Have no effect
Require less air pressure

Correct. Out-of-adjustment slack adjusters reduce braking force at the wheel, increasing stopping distance and risking brake failure on long downgrades.

Question 12 of 20

In a dual air-brake system, the time required for air pressure to build from 85 to 100 psi should be no more than:

15 seconds
30 seconds
45 seconds
120 seconds

Correct. In dual air-brake systems, air should build from 85 to 100 psi within 45 seconds at engine governed RPM.

Question 13 of 20

You hear a steady "ssss" sound while parked with the engine off. This is most likely:

Normal venting
An air leak that needs immediate attention
The compressor running
Trailer brakes releasing

Correct. A steady hiss with the engine off indicates an air leak — find and repair before driving.

Question 14 of 20

The parking-brake control:

Is a yellow diamond-shaped knob
Is a red round knob
Is a green knob
Does not exist on modern trucks

Correct. The parking-brake control is a yellow diamond-shaped knob, distinct from the red round trailer-supply knob.

Question 15 of 20

Brake drums or discs that have cracks larger than ___ the width of the friction area should be replaced:

One-quarter
One-half
One-third
Three-quarters

Correct. Cracks longer than one-half the width of the friction area indicate the drum is unsafe and must be replaced.

Question 16 of 20

When should you use the trailer hand valve to slow the rig?

Whenever you want trailer-only braking
Never; using the trailer hand valve alone can cause a trailer skid
Always when going downhill
Only on dry pavement

Correct. Using the trailer hand valve alone applies brakes only at the trailer wheels and can cause the trailer to lock up and skid. Always use the foot valve to brake.

Question 17 of 20

The spring brakes:

Are held off by air pressure and apply automatically when pressure drops
Are activated only by the foot valve
Are activated only by the trailer hand valve
Are not used in modern trucks

Correct. Spring brakes use heavy springs that apply the brake when air pressure is released or drops below 20-45 psi — they serve as both parking and emergency brake.

Question 18 of 20

Air storage tanks are used to:

Carry coolant
Hold compressed air for use by the brakes
Store fuel
House the alternator

Correct. Air storage (or "supply") tanks hold compressed air ready for brake application. Trucks have multiple tanks for redundancy.

Question 19 of 20

When the air-pressure protection valve closes during driving (because pressure dropped too low), the trailer:

Continues without effect
Spring brakes apply, and the trailer stops
Loses electrical power
Turns off its lights

Correct. When tractor air pressure falls into the 20-45 psi range, the protection valve closes, cutting trailer air, which causes the trailer spring brakes to apply.

Question 20 of 20

To check air-brake adjustment quickly, you can:

Measure the slack adjuster pushrod travel; if it has moved more than about 1 inch when brakes are applied at 90+ psi, adjustment is needed
Listen to the sound
Look at the tires
Check the dashboard light

Correct. Pushrod travel beyond about 1 inch (varies by chamber size) indicates an adjustment issue. Use a marked stroke check or have a mechanic verify.

About the Illinois Air Brakes exam

States typically administer 25 Air Brakes questions and require 80% to pass. Questions cover air-brake system parts, dual systems, supply pressure, brake-system warning, slack adjusters, the parking brake, the spring brake, the pre-trip air-system check, and the proper way to perform a leakage-rate test.

The Illinois Secretary of State Commercial Driver Licensing follows the federal CDL standards established by FMCSA. To earn the Air Brakes credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Air Brakes question bank or browse all Illinois CDL practice tests.