Idaho Air Brakes CDL Practice Test

This is a free 20-question practice test for the Air Brakes portion of the Idaho Commercial Driver's License knowledge exam. Questions are pulled from a pool of 71 drawn from the AAMVA CDL Manual, which is the source document the Idaho Transportation Department Division of Motor Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Idaho.

Question 1 of 20

The supply pressure gauges show:

The brake-pedal pressure
The pressure in the air storage tanks
The amount of air being used by the brakes
The trailer brake pressure only

Correct. The supply (primary and secondary) pressure gauges show air pressure available for braking — a critical reading before driving and during operation.

Question 2 of 20

Pre-trip air-brake check (Step 1) is to:

Test the parking brake
Test the air leakage rate
Time the air-pressure build-up
Check the slack adjusters

Correct. In the seven-step air-brake check the first step is testing the parking brake — release service brakes, set parking brake, gently try to move the vehicle in low gear.

Question 3 of 20

The "brake-system warning device" must come on no later than:

10 psi
30 psi
60 psi
100 psi

Correct. A federal-rule low-air-pressure warning device must activate at or before 60 psi.

Question 4 of 20

If you must drive a vehicle with manual front-wheel-brake limiting valve, you should keep it in the "normal" position:

Always
Only on slick roads
In the slippery position only
Only when empty

Correct. Keep the front-wheel limiting valve in the "normal" position. Modern trucks rarely have this valve, but if equipped, leaving it in "slippery" reduces front braking and lengthens stopping distance.

Question 5 of 20

The "tractor protection valve" closes (cuts off air to the trailer) automatically when:

You apply the brakes
Air pressure in the tractor drops to a dangerously low level (typically 20 to 45 psi)
You hit a bump
You shift gears

Correct. The tractor protection valve protects the tractor from a runaway air loss in case of a trailer break-away or air leak — it closes between 20 and 45 psi.

Question 6 of 20

A yellow ABS malfunction lamp on the trailer (typically left side) means:

The trailer brakes have failed
The trailer ABS is malfunctioning
The trailer is overweight
Tire pressure is low

Correct. A trailer-mounted yellow ABS lamp indicates the trailer's ABS is malfunctioning. Service brakes still work; have the system repaired.

Question 7 of 20

Total stopping distance with air brakes equals:

Perception distance + reaction distance + brake-lag distance + effective braking distance
Reaction distance only
Brake-lag distance only
Perception distance + braking distance

Correct. Add brake-lag distance to the standard perception + reaction + braking distance for any vehicle with air brakes.

Question 8 of 20

The brake-system warning light or buzzer is designed to alert you when:

The brakes are working
Air pressure has dropped below the level needed to brake safely
Brake fluid is low
You haven't serviced the brakes recently

Correct. The brake-system warning device alerts you to dangerous low air pressure — typically activating at or before 60 psi.

Question 9 of 20

You should never use the parking brake when the brakes are very hot because:

It will not hold
It can damage the brakes or cause warpage
It will release on its own
It will use too much air

Correct. Hot brakes cooled with parking brake applied can warp the drum or rotor, or cause the spring brake to fail to release.

Question 10 of 20

Slack adjusters need to be checked because:

They wear and require adjustment to maintain braking force
They never need attention
They are decorative
They affect only the parking brake

Correct. Slack adjusters control how far the pushrod must travel to apply the brake. Out-of-adjustment slack adjusters are the leading mechanical cause of out-of-service violations.

Question 11 of 20

In a dual air-brake system, the time required for air pressure to build from 85 to 100 psi should be no more than:

15 seconds
30 seconds
45 seconds
120 seconds

Correct. In dual air-brake systems, air should build from 85 to 100 psi within 45 seconds at engine governed RPM.

Question 12 of 20

You should test the parking brake by:

Pushing on it
Setting it, releasing service brakes, and gently trying to move the vehicle in low gear — it should hold
Driving without it
Banging on it with a hammer

Correct. After applying the parking brake and releasing the service brakes, gently try to move forward in low gear. If the vehicle moves, the parking brake is not holding.

Question 13 of 20

In a fully charged dual air-brake system at idle, you should test the low-pressure warning by:

Letting the air bleed down with the engine off and brakes off, fanning the brakes if needed; warning should activate at or before 60 psi
Holding the foot valve down for one minute
Removing the alternator belt
Disconnecting the compressor

Correct. Engine off, fan the brake pedal to bleed pressure. The low-pressure warning device should activate before pressure drops below 60 psi.

Question 14 of 20

You are driving a tractor-trailer with the air-pressure gauge dropping rapidly. You should:

Continue to your destination
Pull over safely as soon as possible
Apply the brakes hard
Speed up to reach a safe place

Correct. A rapid drop in air pressure indicates a serious leak. Pull over before the pressure drops to the point where the spring brakes apply and the vehicle stops on the road.

Question 15 of 20

Air-brake adjustment is critical because out-of-adjustment brakes:

Reduce stopping power and can cause failure on long downgrades
Improve fuel economy
Have no effect
Require less air pressure

Correct. Out-of-adjustment slack adjusters reduce braking force at the wheel, increasing stopping distance and risking brake failure on long downgrades.

Question 16 of 20

The trailer air-supply control:

Is a yellow diamond knob
Is a red eight-sided (octagonal) knob
Is a green knob
Is the same knob as the parking brake

Correct. The trailer air-supply (tractor protection) is a red eight-sided knob. Push in to supply air to the trailer; pull out to shut off air.

Question 17 of 20

The parts of an air-brake system include:

Air compressor, governor, air storage tanks, foot valve, and brake chambers
Master cylinder, brake fluid, and calipers
Hydraulic pump, lines, and disc rotors
Vacuum booster and reservoir

Correct. Air-brake systems use a compressor, governor, storage tanks, foot valve, and brake chambers — distinct from hydraulic systems used in cars.

Question 18 of 20

Modulating valves on the trailer:

Don't exist
Apply increasing brake pressure as you push the foot valve harder
Are emergency-only
Open the parking brake

Correct. The trailer service brakes are modulated — pressing harder on the foot valve produces more brake-chamber pressure at the trailer.

Question 19 of 20

The S-cam:

Is a type of fuel pump
Forces the brake shoes against the drum to provide braking action
Adjusts the slack adjuster
Is the parking-brake control

Correct. When the foot valve is pressed, air pushes the brake-chamber pushrod, which moves the slack adjuster, which rotates the S-cam shaft, forcing the shoes against the drum.

Question 20 of 20

When you make a normal stop with air brakes, you should:

Push the brake pedal down hard
Apply firm steady pressure to slow you smoothly
Pump the brakes
Use only the trailer brake

Correct. For normal stops, apply steady firm pressure on the foot valve and adjust to maintain a smooth stop.

About the Idaho Air Brakes exam

States typically administer 25 Air Brakes questions and require 80% to pass. Questions cover air-brake system parts, dual systems, supply pressure, brake-system warning, slack adjusters, the parking brake, the spring brake, the pre-trip air-system check, and the proper way to perform a leakage-rate test.

The Idaho Transportation Department Division of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Air Brakes credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Air Brakes question bank or browse all Idaho CDL practice tests.