Hawaii Combination Vehicles CDL Practice Test
This is a free 20-question practice test for the Combination Vehicles portion of the Hawaii Commercial Driver's License knowledge exam. Questions are pulled from a pool of 55 drawn from the AAMVA CDL Manual, which is the source document the Hawaii Driver License Office uses to write its actual exam.
How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Hawaii.
Question 1 of 20
Off-tracking refers to:
Correct. Off-tracking is the tendency for trailer wheels to follow a smaller-radius path than the tractor wheels through a turn, more pronounced with longer wheelbases.
Question 2 of 20
When making a right turn at an intersection in a tractor-trailer:
Correct. Make the turn from the right lane. If you must swing wide, do so as you complete the turn, never before — swinging left first invites a vehicle to pass on your right.
Question 3 of 20
Before backing under a trailer to couple, you should:
Correct. Trailer should be just low enough that the fifth wheel will lift it slightly. Too low: the fifth wheel hits the trailer body. Too high: the fifth wheel slides under without engaging the kingpin.
Question 4 of 20
A "trailer skid" happens when:
Correct. When trailer wheels lose traction (often from over-application of trailer brakes alone), the trailer can slide sideways — a trailer skid or trailer swing.
Question 5 of 20
If the trailer is too low for coupling, you should:
Correct. Use the landing gear hand crank to raise the trailer to the proper height (just below fifth-wheel level) before backing under.
Question 6 of 20
Front-trailer (lead) wheels lock and the trailer behind continues forward — this is:
Correct. When the trailer wheels lose traction and the front-of-trailer pivots while the tractor continues forward, the result is a trailer jackknife.
Question 7 of 20
To recover from a trailer skid, you should:
Correct. Release the brakes so the trailer wheels can rotate again and re-establish traction. Continued braking will worsen the skid.
Question 8 of 20
When you couple, the locking jaws of the fifth wheel must close around:
Correct. The locking jaws must engage the kingpin shank below the head. If the jaws close above the head, the connection is unsafe.
Question 9 of 20
When backing a tractor-trailer in a straight line, you should:
Correct. When backing straight, watch the trailer in your mirrors and make small steering corrections to keep it tracking straight. Big corrections lead to jackknifing.
Question 10 of 20
Red and amber lights on the rear of the trailer must be:
Correct. Brake lights, turn signals, marker lights, and reflectors at the rear must be operational and clean. Damaged or non-working lights are an out-of-service item.
Question 11 of 20
When coupling, after backing under the trailer, you should:
Correct. A tug test confirms the kingpin is fully engaged. Skipping it is the leading cause of trailer drops shortly after coupling.
Question 12 of 20
A high-mounted trailer kingpin is dangerous because:
Correct. If the trailer is too high, the fifth wheel slides under without the kingpin engaging the locking jaws. The trailer is not coupled and can drop when you pull away.
Question 13 of 20
Before uncoupling, you should:
Correct. Proper sequence: park level, lower landing gear to support the trailer, disconnect lines, release jaws, then pull forward slowly. Skipping any step risks dropping the trailer.
Question 14 of 20
Trailer rollover is more likely when:
Correct. High cargo and uneven side-loading raise the center of gravity, increasing rollover risk on curves and ramps.
Question 15 of 20
Cargo securement: the heaviest part of the load should be:
Correct. Loading heavy cargo to the front of the trailer over the drive axles helps with traction; loading to one side or top creates dangerous handling.
Question 16 of 20
The air lines connecting the tractor and trailer are:
Correct. The red glad-hand carries emergency/supply air; the blue glad-hand carries service air. They cross to keep matched colors when coupling.
Question 17 of 20
When approaching a curve in a tractor-trailer, you should:
Correct. Slow before entering the curve. Once in the curve, accelerate gently to maintain stability. Braking in a curve invites trailer skid or rollover.
Question 18 of 20
When inspecting the kingpin during pre-trip, look for:
Correct. A worn, cracked, or bent kingpin can fail under load. The locking jaws must close completely around the shank, not just the head.
Question 19 of 20
A combination vehicle requires more time to stop than a single vehicle because:
Correct. Greater weight + brake-lag in long air lines = longer stopping distance. Plan ahead.
Question 20 of 20
A loaded trailer "bows" (sways) at speed because:
Correct. Crosswinds and uneven loading can produce trailer sway. Slow down and allow the sway to dampen; do not over-correct with steering.
About the Hawaii Combination Vehicles exam
Most states administer 20 Combination Vehicles questions and require 80% to pass. The exam emphasizes the unique handling of articulated vehicles: how trailers track behind the tractor, how to prevent rollover, how to manage rearward amplification with multi-trailer combinations, and the correct sequence to couple and uncouple.
The Hawaii Driver License Office follows the federal CDL standards established by FMCSA. To earn the Combination Vehicles credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.
Want more practice? Try the full Combination Vehicles question bank or browse all Hawaii CDL practice tests.