Florida Combination Vehicles CDL Practice Test

This is a free 20-question practice test for the Combination Vehicles portion of the Florida Commercial Driver's License knowledge exam. Questions are pulled from a pool of 55 drawn from the AAMVA CDL Manual, which is the source document the Florida Department of Highway Safety and Motor Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Florida.

Question 1 of 20

When approaching a curve in a tractor-trailer, you should:

Brake during the curve
Slow down before entering the curve
Speed up
Maintain steady speed

Correct. Slow before entering the curve. Once in the curve, accelerate gently to maintain stability. Braking in a curve invites trailer skid or rollover.

Question 2 of 20

A sliding fifth wheel allows you to:

Adjust the weight distribution between drive axles and trailer axles
Speed up
Slow down
Disable the trailer brakes

Correct. Sliding fifth wheels move forward to put more weight on drive axles or aft to reduce drive-axle weight, helping comply with axle-weight limits.

Question 3 of 20

Most jackknifes happen because:

Drive wheels skid during braking on slippery surfaces
Brakes work too well
The road is dry
Cargo is too light

Correct. Loss of traction on the tractor drive axles during braking — typically on slick surfaces or with overly aggressive braking — causes a jackknife.

Question 4 of 20

During a pre-trip inspection, you should also check that the cargo:

Is loaded inside the vehicle
Is secured, balanced, within weight limits, and within size limits
Is brightly colored
Is all the same shape

Correct. Cargo securement, weight balance, and size compliance are all driver responsibilities — check before each trip.

Question 5 of 20

A safe practice when arriving at a destination is to:

Pull straight in fast
Pull straight ahead, slowly, watching mirrors and clearance
Back in without help
Stop on the road

Correct. Slow approach with mirror checks gives time to identify clearance issues and pedestrians.

Question 6 of 20

The air lines connecting the tractor and trailer are:

Red (emergency) and blue (service)
Red and yellow
Blue and yellow
Black and red

Correct. The red glad-hand carries emergency/supply air; the blue glad-hand carries service air. They cross to keep matched colors when coupling.

Question 7 of 20

Front-trailer (lead) wheels lock and the trailer behind continues forward — this is:

Trailer jackknife
Tractor jackknife
Tire blowout
Off-tracking

Correct. When the trailer wheels lose traction and the front-of-trailer pivots while the tractor continues forward, the result is a trailer jackknife.

Question 8 of 20

When you "G.O.A.L." in trucking, you:

Get Off And Look — visually verify the area before backing
Go Over A Limit
Grab On And Lift
Greet Other Approaching Loaders

Correct. G.O.A.L. — Get Out And Look — is the universal driver-school rule before any tight backing maneuver.

Question 9 of 20

Trailer cargo can shift if:

Securement is inadequate, the load was packed unevenly, or the rig undergoes hard braking or sharp turns
Cargo never shifts
Roads are smooth
Trailer is empty

Correct. Inadequate securement, uneven packing, hard braking, sharp turns, or rough roads can all shift cargo. Inspect cargo periodically en route.

Question 10 of 20

A sliding fifth wheel that is unlocked or improperly secured can:

Slide unexpectedly during braking or acceleration, dangerously changing handling
Improve fuel economy
Save time
Have no effect

Correct. An unsecured sliding fifth wheel can shift during braking, changing the rig's handling unpredictably. Always verify the lock pin is engaged.

Question 11 of 20

The most likely cause of a tractor jackknife is:

Light cargo
Drive wheels lock during braking
Slow speed
Loose load

Correct. When drive wheels lose traction (locked, oversteer, ice), the tractor pivots ahead of the trailer — a jackknife.

Question 12 of 20

When coupling, after backing under the trailer, you should:

Pull the trailer immediately
Perform a tug test (gently pulling forward in low gear with trailer brakes set) to confirm the kingpin is locked
Disconnect the air lines
Lower the landing gear

Correct. A tug test confirms the kingpin is fully engaged. Skipping it is the leading cause of trailer drops shortly after coupling.

Question 13 of 20

When inspecting the kingpin during pre-trip, look for:

Excessive wear, bending, cracks, or improper lock-jaw engagement
Only the color
Only the size
Only the grease

Correct. A worn, cracked, or bent kingpin can fail under load. The locking jaws must close completely around the shank, not just the head.

Question 14 of 20

When making a turn, you should signal:

Just before the turn
Well in advance — at least 100 feet for a turn at low speed
Only if other vehicles are present
At the start of the turn

Correct. Signal early enough that other drivers see and process the signal — generally at least 100 feet before in town, longer at highway speeds.

Question 15 of 20

When you supply air to the trailer for the first time after coupling, you should:

Wait until air pressure builds in the trailer reservoir, then test the trailer brakes by pulling out the trailer-supply knob
Drive away immediately
Disconnect the lines
Skip the test

Correct. Charge the trailer system. Then test the trailer brake function by tugging gently or pulling the trailer-supply knob to confirm trailer brakes apply.

Question 16 of 20

Combination vehicles are usually:

Easier to drive than single trucks
Harder to drive than single trucks because of length, weight, and the unique handling of articulated vehicles
The same as single trucks
Faster than single trucks

Correct. Combination vehicles (tractor-trailer rigs) are heavier, longer, and articulate at the fifth wheel — all making them more demanding than single-unit trucks.

Question 17 of 20

To make a trailer go where you want when backing, the steering wheel should:

Be turned in the direction you want the trailer to go
Be turned opposite to the direction you want the trailer to go (then corrected)
Stay still
Be held lightly

Correct. Backing is opposite-direction steering: to swing the trailer right, turn the wheel left first, then correct as the trailer follows.

Question 18 of 20

Length and weight increase what about a combination vehicle?

Stopping distance, off-tracking, blind spots, and time required for lane changes
Visibility
Speed
Acceleration

Correct. Longer, heavier rigs need more stopping distance, swing wider in turns, have larger blind spots, and require more time and space to change lanes.

Question 19 of 20

When backing a tractor-trailer in a straight line, you should:

Let the trailer drift wherever it goes
Make small steering corrections to keep the trailer in line
Apply heavy brake pressure
Use the trailer hand valve

Correct. When backing straight, watch the trailer in your mirrors and make small steering corrections to keep it tracking straight. Big corrections lead to jackknifing.

Question 20 of 20

When making a right turn at an intersection in a tractor-trailer:

Swing to the left first to make room for the right turn
Make the turn from the right lane and swing wide as needed at the end of the turn
Make the turn at high speed
Stay in the left lane through the turn

Correct. Make the turn from the right lane. If you must swing wide, do so as you complete the turn, never before — swinging left first invites a vehicle to pass on your right.

About the Florida Combination Vehicles exam

Most states administer 20 Combination Vehicles questions and require 80% to pass. The exam emphasizes the unique handling of articulated vehicles: how trailers track behind the tractor, how to prevent rollover, how to manage rearward amplification with multi-trailer combinations, and the correct sequence to couple and uncouple.

The Florida Department of Highway Safety and Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Combination Vehicles credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Combination Vehicles question bank or browse all Florida CDL practice tests.