Connecticut Tanker CDL Practice Test

This is a free 20-question practice test for the Tanker portion of the Connecticut Commercial Driver's License knowledge exam. Questions are pulled from a pool of 50 drawn from the AAMVA CDL Manual, which is the source document the Connecticut Department of Motor Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Connecticut.

Question 1 of 20

Tanker pre-trip should specifically check:

Tank shell, intake/discharge/cut-off valves, manhole covers, venting devices, and pressure-relief equipment
Only the tires
Only the engine
Only the placards

Correct. In addition to standard pre-trip, inspect the tank shell, all valves, manhole covers, vents, and pressure-relief devices.

Question 2 of 20

Vapor recovery during loading:

Is used at terminals to capture flammable vapors
Replaces the cargo
Is forbidden
Is used only at night

Correct. Vapor recovery captures flammable vapors displaced as product is loaded, returning them to storage. Required at most modern fuel terminals.

Question 3 of 20

Tankers have a high center of gravity because:

The driver sits high
The load is in a tall, narrow tank
The cargo is light
The cab is wide

Correct. A tank carries its load high above the road. The center of gravity is much higher than for a flatbed of the same weight, increasing rollover risk.

Question 4 of 20

A tanker hauling food-grade product (e.g., milk):

Often uses a smooth-bore tank for cleaning
Uses a baffled tank
Uses a compartmented tank only
Uses no tank

Correct. Smooth-bore tanks (no internal baffles) are easier to clean for food-grade products. The trade-off is severe surge — drive slower and brake earlier.

Question 5 of 20

When the surge in a tanker pushes the rig forward at a stop, you may:

Brake harder
Be pushed past the intended stopping point
Skid backward
Have no effect

Correct. Forward surge can push the entire rig forward — past stop lines, into intersections, into the vehicle ahead. Plan your stops with extra distance.

Question 6 of 20

A double trailer tanker requires:

Both N (Tanker) and T (Doubles/Triples) endorsements, plus possibly H (Hazmat)
Only the N endorsement
No endorsements
Only the H endorsement

Correct. Pulling more than one tank requires Doubles/Triples (T) plus Tanker (N) endorsements. Add Hazmat (H) — together written X — for hazardous liquid loads.

Question 7 of 20

When you drive a tanker on slippery roads, you should:

Drive faster
Reduce speed substantially and increase following distance
Use only the trailer brake
Maintain normal speed

Correct. Reduce speed by at least one-third on wet roads, by half on snow. Liquid loads make recovery from a skid much harder.

Question 8 of 20

In the event of a fire on a tanker:

Pull off the road, away from buildings, get out, call 911, and use the ERG to identify the response
Continue to deliver
Pour water on a fuel fire
Drive faster to put out the wind

Correct. Pull to a safe area, away from buildings and people. Get out, call 911, and consult the ERG. Some tank fires (e.g., water on flammable liquid) make matters worse.

Question 9 of 20

When you stop a placarded tanker carrying flammable liquid at a railroad crossing, you must stop:

On the rails
Between 15 and 50 feet from the nearest rail, then proceed only when safe
Anywhere
Only if a train is in sight

Correct. Placarded hazmat (which most fuel tankers are) must stop 15 to 50 feet from the nearest rail. Look, listen, and cross only when clear.

Question 10 of 20

A tanker with an empty compartment between two full compartments may:

Slosh forward and backward, hard to predict
Be smoother
Drive itself
Have no surge

Correct. Mixed full and empty compartments produce complex surge patterns. Plan acceleration and braking conservatively.

Question 11 of 20

A heavy liquid load with a baffled tank may still surge:

Front-to-back, despite the baffles
Not at all
Less than smooth-bore but baffles do not stop side-to-side surge
None of the above

Correct. Baffles reduce front-to-back surge but do not affect side-to-side surge — bulkheads are typically transverse, not longitudinal.

Question 12 of 20

When carrying water (a non-hazmat liquid) in a tanker, you still need:

The N endorsement, because it is a tank vehicle
No endorsement
Only the H endorsement
Just a Class B

Correct. The N endorsement is based on the vehicle being a tank, not on the cargo. Even non-hazardous water requires the N endorsement if the tank meets size criteria.

Question 13 of 20

Outage requirements:

Vary by liquid because of differing thermal expansion rates
Are always 1 percent
Do not exist
Are only for water

Correct. Outage requirements differ by product. Gasoline expands more than diesel, ethanol expands differently, etc. Check the shipping paper or product specifications.

Question 14 of 20

Cargo tanks must be inspected and tested:

Periodically per CFR requirements; intervals depend on tank specification (MC-306, MC-307, MC-312, DOT-406, etc.)
Once a decade
Never
Only when leaks appear

Correct. Cargo tanks have specific inspection and test schedules based on their DOT specification (visual, leakage, internal, pressure, and thickness tests).

Question 15 of 20

A pressure-relief device that vents during transit:

Is a normal occurrence
Is a serious malfunction or over-fill — stop and investigate
Means the tank is empty
Means the load is cold

Correct. Continuous venting indicates over-pressure (often from over-fill or sun heating an over-filled tank). Stop and investigate; do not continue with a venting tank.

Question 16 of 20

Loading dock procedure for cargo tanks of flammable liquid:

Set parking brake, chock wheels, shut off engine, ground and bond, monitor loading, follow loading-rack procedures
Leave the engine running
Skip the chocks
Smoke nearby

Correct. Standard loading-rack procedure: brake set, chocks in, engine off, bond and ground, monitor loading, follow rack-specific procedures (vapor recovery, load arms, etc.).

Question 17 of 20

Tank specification "MC-307" or "DOT-407" generally refers to:

Cargo tanks for low-pressure liquids and certain hazardous chemicals
Explosives
Bulk solids
Refrigerated gases

Correct. MC-307/DOT-407 are insulated low-pressure tanks for chemicals — common for many industrial liquids.

Question 18 of 20

A "smooth bore" tank has:

No internal divisions
Internal baffles
Compartments
Reinforcement rings

Correct. A smooth-bore tank has no internal divisions or baffles. Surge is dramatic; brake gently to avoid being pushed forward by the load.

Question 19 of 20

Empty tankers handle:

The same as loaded tankers
Differently — lighter axle weight reduces braking traction; tankers are also more affected by crosswinds when empty
Always better
Always worse

Correct. Empty tankers have less brake traction (less weight on tires) and are more affected by crosswinds. Never assume empty equals safer.

Question 20 of 20

When loading a cargo tank with flammable liquid, the driver must:

Stay alert, within 25 feet, with a clear view of the tank, and ready to handle emergencies
Leave for lunch
Smoke
Run the engine at high RPM

Correct. Federal rule: driver remains within 25 feet, alert, with a clear view, ready to act in case of overflow or emergency.

About the Connecticut Tanker exam

Most states administer 20 Tanker questions and require 80% to pass. Topics include the unique handling of liquid loads, surge effects, baffles vs. smooth-bore, outage and expansion, inspection of the cargo tank, and emergency procedures.

The Connecticut Department of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Tanker credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Tanker question bank or browse all Connecticut CDL practice tests.