Connecticut Doubles/Triples CDL Practice Test
This is a free 20-question practice test for the Doubles/Triples portion of the Connecticut Commercial Driver's License knowledge exam. Questions are pulled from a pool of 50 drawn from the AAMVA CDL Manual, which is the source document the Connecticut Department of Motor Vehicles uses to write its actual exam.
How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Connecticut.
Question 1 of 20
Crosswinds are particularly hazardous for:
Correct. Empty trailers in a multi-trailer rig present a large flat surface to crosswinds — a strong gust can blow the rear trailer over.
Question 2 of 20
A safe practice when starting from a stop with doubles:
Correct. Sudden acceleration can cause the rear trailer to sway. Start gently in low gear.
Question 3 of 20
On a steep downgrade with doubles, you should:
Correct. Same rule as any combination vehicle, but plan extra margin: doubles take longer to stop and the rear trailer may push.
Question 4 of 20
Before connecting a converter dolly, you should:
Correct. Pre-trip the dolly: tires, brake adjustment, fifth-wheel jaws (open and clean), pintle hook, electrical receptacle, lights.
Question 5 of 20
During a pre-trip on doubles, the trailer-supply line:
Correct. The supply line carries air from tractor through every trailer; verify open valves at every coupled connection and a closed valve at the rear of the rear-most trailer.
Question 6 of 20
When pulling triples, you should:
Correct. Stay right, plan lane changes well in advance, signal early, and avoid abrupt steering. Triples crack-the-whip violently.
Question 7 of 20
When testing the brakes on a doubles rig:
Correct. Test the entire rig: build-up time, leakage, low-pressure warning, parking brake, and confirm rear-trailer brake function.
Question 8 of 20
A "drive-axle skid" on a doubles rig:
Correct. A drive-axle skid leads to tractor jackknife. With trailers behind, the situation gets worse fast — the rear trailers can swing wildly.
Question 9 of 20
When inspecting a doubles rig, the lights on the rear of the rear-most trailer must:
Correct. Brake, turn, and marker lights at the rear of the rearmost trailer must be working and visible — that is what following traffic sees.
Question 10 of 20
When you encounter a breakaway in your doubles (a trailer separates):
Correct. Maintain control of what remains, brake gently and progressively, secure the area with warning devices, contact dispatch.
Question 11 of 20
A tractor pulling doubles cannot brake as quickly as a tractor pulling a single trailer because:
Correct. Greater weight and longer air lines mean longer braking distance. Plan stopping distance with extra margin.
Question 12 of 20
When pulling a single trailer and trying to figure out if you should add a doubles endorsement:
Correct. The T endorsement is required only when you actually operate doubles or triples. Single-trailer operations do not require it.
Question 13 of 20
In a multi-trailer combination, the most violent movement during evasive maneuvers happens at:
Correct. Rearward amplification (crack-the-whip effect) is greatest at the rear-most trailer. The last trailer in a triple can be thrown sideways with much greater force than the tractor.
Question 14 of 20
When inspecting a converter dolly, the pintle hook must:
Correct. The pintle hook must close fully around the lunette eye, with no excessive wear or cracks. Add safety chains as backup.
Question 15 of 20
A converter dolly is:
Correct. A converter dolly has a small frame, axle(s), and a fifth wheel mounted on top — it transforms a semi-trailer into a full trailer behind another trailer.
Question 16 of 20
When you uncouple a converter dolly, you should:
Correct. Park level, disconnect air and electric, lower trailer landing gear if applicable, remove safety chains, then release the pintle hook to free the dolly.
Question 17 of 20
Triples are restricted in many states. You should:
Correct. Many states restrict triples to specific routes (turnpikes, designated corridors). Verify legality and route before crossing into a state.
Question 18 of 20
When pulling doubles in a tunnel:
Correct. Tunnel clearance can be tight for long doubles — watch overhead and side clearance, and respect any vehicle-class restrictions.
Question 19 of 20
The driver of a doubles rig should:
Correct. Smooth, gradual inputs are critical. Avoid abrupt steering and abrupt braking.
Question 20 of 20
Driving doubles or triples on the highway:
Correct. Multi-trailer rigs are more sensitive to abrupt steering, take longer to brake, and amplify any movement to the rear. Be gentle and plan ahead.
About the Connecticut Doubles/Triples exam
Most states administer 20 Doubles/Triples questions and require 80% to pass. The exam emphasizes coupling and uncoupling the converter dolly, rearward amplification (the "crack-the-whip" effect), and the unique inspection and handling demands of multi-trailer rigs.
The Connecticut Department of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Doubles/Triples credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.
Want more practice? Try the full Doubles/Triples question bank or browse all Connecticut CDL practice tests.