Colorado Air Brakes CDL Practice Test

This is a free 20-question practice test for the Air Brakes portion of the Colorado Commercial Driver's License knowledge exam. Questions are pulled from a pool of 71 drawn from the AAMVA CDL Manual, which is the source document the Colorado Division of Motor Vehicles uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Colorado.

Question 1 of 20

In a dual air-brake system, you should let the air pressure build to at least what level before driving?

60 psi
80 psi
100 psi
125 psi

Correct. Wait until the system pressure is at least 100 psi before driving in a dual air-brake system.

Question 2 of 20

The governor controls:

Engine RPM
When the air compressor pumps air into the air storage tanks
Brake-pedal travel
Trailer hand-valve operation

Correct. The governor cycles the compressor: it cuts the compressor in around 100 psi and cuts it out around 125 psi.

Question 3 of 20

Manual slack adjusters must be adjusted:

Only by a mechanic at the dealership
By the driver, when needed, following manufacturer specifications
Never
Only at the time of vehicle inspection

Correct. Drivers may adjust manual slack adjusters in compliance with manufacturer specifications. Automatic slack adjusters are now standard but still require periodic checking.

Question 4 of 20

A condition called "brake fade" is most likely on:

Long downgrades
Flat highway
Backing into a dock
Fueling

Correct. Brake fade comes from heat from extended use — most commonly on long, steep downgrades where the brakes are working continuously.

Question 5 of 20

If you must drive a vehicle with manual front-wheel-brake limiting valve, you should keep it in the "normal" position:

Always
Only on slick roads
In the slippery position only
Only when empty

Correct. Keep the front-wheel limiting valve in the "normal" position. Modern trucks rarely have this valve, but if equipped, leaving it in "slippery" reduces front braking and lengthens stopping distance.

Question 6 of 20

The supply pressure gauges show:

The brake-pedal pressure
The pressure in the air storage tanks
The amount of air being used by the brakes
The trailer brake pressure only

Correct. The supply (primary and secondary) pressure gauges show air pressure available for braking — a critical reading before driving and during operation.

Question 7 of 20

The application pressure gauge shows:

The pressure in the storage tanks
How much pressure is being applied to the brakes when you press the foot valve
Tire pressure
Engine oil pressure

Correct. The application gauge (when present) shows brake-application pressure — useful for spotting brake-system problems on long downgrades.

Question 8 of 20

You should perform a static air-leakage test by:

Driving and watching the gauge
With the engine off, brakes released, watching air pressure for one minute
With the engine running at high RPM
By tapping the air tank with a wrench

Correct. Engine off, brakes released, fully charged system: watch for air loss over one minute. Then apply brakes and check again.

Question 9 of 20

When checking the brakes on a downgrade, you should:

Use the air-pressure gauge to monitor brake-system pressure for excessive use
Pump the pedal
Drive faster
Ignore the gauge

Correct. Watch the air-pressure gauge. If pressure drops faster than the compressor can recover, brakes are being used too aggressively for the gear selection.

Question 10 of 20

A long downgrade requires:

Riding the brakes the whole way
Selecting a low gear before starting down and using intermittent firm brake applications
Coasting in neutral
Using the engine brake only

Correct. Pick a low gear before starting down. Use the brakes in firm, intermittent applications: brake to 5 mph below safe speed, release, repeat.

Question 11 of 20

You should drain the air tanks:

Once a month
Once a year
At the end of every working day
Never

Correct. Drain all air tanks at the end of each working day to remove water and compressor oil that has condensed in the tanks.

Question 12 of 20

In an emergency stop on a non-ABS vehicle, you should:

Apply the brakes lightly
Use stab braking — full brake until wheels lock, release, repeat
Pump the brakes rapidly
Apply only the trailer hand valve

Correct. Stab braking applies brakes hard until the wheels lock, then releases when you feel skid — this slows the vehicle while keeping it straight.

Question 13 of 20

The parts of an air-brake system include:

Air compressor, governor, air storage tanks, foot valve, and brake chambers
Master cylinder, brake fluid, and calipers
Hydraulic pump, lines, and disc rotors
Vacuum booster and reservoir

Correct. Air-brake systems use a compressor, governor, storage tanks, foot valve, and brake chambers — distinct from hydraulic systems used in cars.

Question 14 of 20

The trailer air-supply control:

Is a yellow diamond knob
Is a red eight-sided (octagonal) knob
Is a green knob
Is the same knob as the parking brake

Correct. The trailer air-supply (tractor protection) is a red eight-sided knob. Push in to supply air to the trailer; pull out to shut off air.

Question 15 of 20

Air storage tanks are used to:

Carry coolant
Hold compressed air for use by the brakes
Store fuel
House the alternator

Correct. Air storage (or "supply") tanks hold compressed air ready for brake application. Trucks have multiple tanks for redundancy.

Question 16 of 20

Wet brakes:

Improve braking
Cause reduced power, brake pulling, or wheel lockup
Have no effect
Are normal in winter

Correct. After fording water, brakes may be wet. Drive slowly while applying light brake pressure to dry them.

Question 17 of 20

When should you NOT use the parking brakes?

When the vehicle is parked
When the brakes are very hot, such as after a long downgrade — they could damage if applied
At any time
When the engine is off

Correct. Hot brakes can be damaged by the spring brakes contracting against hot drums. Let the brakes cool before parking.

Question 18 of 20

Air tanks must be drained because:

They get heavy
Compressor oil and water can collect inside, contaminating the brake system
They expire
It is required after every trip

Correct. Water and compressor oil collect at the bottom of air tanks. They must be drained to keep the system clean and prevent winter freeze-ups.

Question 19 of 20

You should never leave the vehicle unattended without:

Locking the doors
Applying the parking brakes and chocking the wheels if necessary
Turning off the radio
Removing the key

Correct. Set the parking brake. On grades or where unintended movement could occur, chock the wheels in addition.

Question 20 of 20

Brake fade is the result of:

Cold brakes
Worn linings only
Heat from continuous use, which reduces braking effectiveness
Air leaks

Correct. Brake fade comes from heat. Manage downgrade speed by gear selection plus intermittent firm brake use, not continuous light pressure.

About the Colorado Air Brakes exam

States typically administer 25 Air Brakes questions and require 80% to pass. Questions cover air-brake system parts, dual systems, supply pressure, brake-system warning, slack adjusters, the parking brake, the spring brake, the pre-trip air-system check, and the proper way to perform a leakage-rate test.

The Colorado Division of Motor Vehicles follows the federal CDL standards established by FMCSA. To earn the Air Brakes credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Air Brakes question bank or browse all Colorado CDL practice tests.