Arizona Doubles/Triples CDL Practice Test

This is a free 20-question practice test for the Doubles/Triples portion of the Arizona Commercial Driver's License knowledge exam. Questions are pulled from a pool of 50 drawn from the AAMVA CDL Manual, which is the source document the Arizona Motor Vehicle Division uses to write its actual exam.

How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Arizona.

Question 1 of 20

Triples are restricted in many states. You should:

Drive triples anywhere
Verify state-by-state legality before crossing into a state
Use a special placard
Avoid driving in cities

Correct. Many states restrict triples to specific routes (turnpikes, designated corridors). Verify legality and route before crossing into a state.

Question 2 of 20

When inspecting a converter dolly, the pintle hook must:

Lock fully closed around the lunette eye
Be loose
Be cracked
Be replaced quarterly

Correct. The pintle hook must close fully around the lunette eye, with no excessive wear or cracks. Add safety chains as backup.

Question 3 of 20

A "drive-axle skid" on a doubles rig:

Can lead to a tractor jackknife and complicated trailer movement behind it
Is harmless
Means the dolly broke
Increases stability

Correct. A drive-axle skid leads to tractor jackknife. With trailers behind, the situation gets worse fast — the rear trailers can swing wildly.

Question 4 of 20

When uncoupling the converter dolly from the lead trailer:

Lower trailer landing gear (if applicable), disconnect air and electrical, remove safety chains, then release pintle hook
Just unhook the chains and pull away
Drive forward fast
Use only the trailer brake

Correct. Standard sequence: support the trailer (landing gear if it is a semi-trailer), disconnect lines, remove chains, release pintle hook.

Question 5 of 20

Crosswinds may cause the rear trailer of a doubles to:

Sway dangerously, especially when empty
Brake automatically
Steer itself
Have no effect

Correct. Empty trailers act as sails. Strong crosswinds can sway or even tip an empty rear trailer. Reduce speed in high winds.

Question 6 of 20

When adjusting the order of trailers in a multi-trailer rig:

Place the heaviest immediately behind the tractor and progressively lighter to the rear
Place the heaviest at the rear
Order does not matter
Order is alphabetical

Correct. Heaviest first, lightest last. This minimizes rearward amplification and rollover risk in the rear trailers.

Question 7 of 20

A driver licensed for Class A with all endorsements may drive any combination vehicle. The T endorsement allows:

Doubles and triples
Hazmat
Tanker
Buses

Correct. T endorsement specifically authorizes doubles and triples. Other endorsements (H, N, P, S) cover other categories.

Question 8 of 20

An empty rear trailer on a multi-trailer rig:

Is more likely to roll over in evasive steering than a loaded one
Is always stable
Cannot roll over
Has no effect

Correct. Lighter trailer = more vulnerable to crack-the-whip and crosswinds. Empty rear trailers in multi-trailer rigs roll easily.

Question 9 of 20

Coupling order for a set of doubles starts with:

Coupling the lead (front) trailer to the tractor first, charging air, then attaching the converter dolly to the rear of the lead trailer, then attaching the second trailer
Coupling the rear trailer first
Coupling the dolly first
It does not matter

Correct. Standard order: tractor + lead trailer first, charge air, then attach converter dolly behind lead trailer, then second trailer to dolly.

Question 10 of 20

Crosswinds are particularly hazardous for:

Empty doubles and triples
Loaded singles
Backing
Slow speeds

Correct. Empty trailers in a multi-trailer rig present a large flat surface to crosswinds — a strong gust can blow the rear trailer over.

Question 11 of 20

During a pre-trip on doubles, the trailer-supply line:

Should be open from tractor to rear-most trailer
Should be open at the front but closed at the rear-most trailer
Should be closed everywhere
Should always be disconnected

Correct. The supply line carries air from tractor through every trailer; verify open valves at every coupled connection and a closed valve at the rear of the rear-most trailer.

Question 12 of 20

You should never:

Quickly steer to the left while pulling triples
Drive at the speed limit
Use turn signals
Stop at intersections

Correct. Sudden steering with triples can cause the rear trailer to roll. Avoid abrupt steering and plan lane changes far in advance.

Question 13 of 20

A safe practice when starting from a stop with doubles:

Accelerate gently to avoid breakaway sway in the second trailer
Floor the accelerator
Use only the trailer hand valve
Skip first gear

Correct. Sudden acceleration can cause the rear trailer to sway. Start gently in low gear.

Question 14 of 20

When pulling doubles in a tunnel:

Stay alert; clearance and turning radius can be tight
Drive faster
Stop in the middle
Honk continuously

Correct. Tunnel clearance can be tight for long doubles — watch overhead and side clearance, and respect any vehicle-class restrictions.

Question 15 of 20

On a triple, the air pressure to the rearmost trailer:

Is the same as the lead
Is delayed by line length, so braking response at the rear trailer lags noticeably
Is faster
Does not exist

Correct. Greater line length = greater brake-lag at the rear. Plan braking earlier than you would for a single trailer.

Question 16 of 20

A tractor pulling doubles cannot brake as quickly as a tractor pulling a single trailer because:

Doubles are heavier and brake response is delayed in longer air lines
Doubles are lighter
Brakes are bigger
Tractors brake better with doubles

Correct. Greater weight and longer air lines mean longer braking distance. Plan stopping distance with extra margin.

Question 17 of 20

The "T" endorsement is required to:

Drive any commercial vehicle
Pull two or more trailers
Drive a bus
Haul hazmat

Correct. The T endorsement is required to pull more than one trailer (doubles or triples).

Question 18 of 20

A converter dolly is:

A small hand truck
A set of axles with a fifth wheel that converts a semi-trailer into a full trailer for use in doubles/triples
A trailer-loading device
A type of brake

Correct. A converter dolly has a small frame, axle(s), and a fifth wheel mounted on top — it transforms a semi-trailer into a full trailer behind another trailer.

Question 19 of 20

Safety chains on a converter dolly are required to:

Prevent the dolly from disconnecting if the pintle hook fails
Decorate the rig
Bind cargo
Add weight

Correct. Safety chains catch the dolly if the pintle hook releases or fails — preventing the trailer behind from breaking loose.

Question 20 of 20

A pintle hook is:

The hitch on the rear of a trailer used to tow another trailer or dolly
The kingpin
The fifth wheel
A type of placard

Correct. The pintle hook is the strong rear-mounted hitch that grips the dolly's lunette eye, allowing one trailer to tow another behind it.

About the Arizona Doubles/Triples exam

Most states administer 20 Doubles/Triples questions and require 80% to pass. The exam emphasizes coupling and uncoupling the converter dolly, rearward amplification (the "crack-the-whip" effect), and the unique inspection and handling demands of multi-trailer rigs.

The Arizona Motor Vehicle Division follows the federal CDL standards established by FMCSA. To earn the Doubles/Triples credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.

Want more practice? Try the full Doubles/Triples question bank or browse all Arizona CDL practice tests.