Alabama Air Brakes CDL Practice Test
This is a free 20-question practice test for the Air Brakes portion of the Alabama Commercial Driver's License knowledge exam. Questions are pulled from a pool of 71 drawn from the AAMVA CDL Manual, which is the source document the Alabama Law Enforcement Agency Driver License Division uses to write its actual exam.
How it works: Click an answer. The correct choice highlights in green, and you'll see a short explanation. Aim for 85% or better before you sit for the real test in Alabama.
Question 1 of 20
The supply pressure gauges show:
Correct. The supply (primary and secondary) pressure gauges show air pressure available for braking — a critical reading before driving and during operation.
Question 2 of 20
Air tanks must be drained because:
Correct. Water and compressor oil collect at the bottom of air tanks. They must be drained to keep the system clean and prevent winter freeze-ups.
Question 3 of 20
When brake drums or shoes get very hot, you should:
Correct. Park where you can let the brakes cool. Do not apply the parking (spring) brake on overheated brakes — it can damage them or cause warpage.
Question 4 of 20
A condition called "brake fade" is most likely on:
Correct. Brake fade comes from heat from extended use — most commonly on long, steep downgrades where the brakes are working continuously.
Question 5 of 20
The S-cam:
Correct. When the foot valve is pressed, air pushes the brake-chamber pushrod, which moves the slack adjuster, which rotates the S-cam shaft, forcing the shoes against the drum.
Question 6 of 20
You should perform a static air-leakage test by:
Correct. Engine off, brakes released, fully charged system: watch for air loss over one minute. Then apply brakes and check again.
Question 7 of 20
You should test the parking brake by:
Correct. After applying the parking brake and releasing the service brakes, gently try to move forward in low gear. If the vehicle moves, the parking brake is not holding.
Question 8 of 20
Modern dual-circuit air-brake systems are required so that:
Correct. Dual systems separate primary and secondary brake circuits so that a failure in one (rear or trailer) still leaves brakes available on the other axle group.
Question 9 of 20
To check air-brake adjustment quickly, you can:
Correct. Pushrod travel beyond about 1 inch (varies by chamber size) indicates an adjustment issue. Use a marked stroke check or have a mechanic verify.
Question 10 of 20
Manual slack adjusters must be adjusted:
Correct. Drivers may adjust manual slack adjusters in compliance with manufacturer specifications. Automatic slack adjusters are now standard but still require periodic checking.
Question 11 of 20
A low-air-pressure warning device must come on at or before:
Correct. A federal-mandated low-air-pressure warning (light, buzzer, or wig-wag) must activate at or before 60 psi.
Question 12 of 20
The spring brakes:
Correct. Spring brakes use heavy springs that apply the brake when air pressure is released or drops below 20-45 psi — they serve as both parking and emergency brake.
Question 13 of 20
The parts of an air-brake system include:
Correct. Air-brake systems use a compressor, governor, storage tanks, foot valve, and brake chambers — distinct from hydraulic systems used in cars.
Question 14 of 20
The parking-brake control:
Correct. The parking-brake control is a yellow diamond-shaped knob, distinct from the red round trailer-supply knob.
Question 15 of 20
When should you use the trailer hand valve to slow the rig?
Correct. Using the trailer hand valve alone applies brakes only at the trailer wheels and can cause the trailer to lock up and skid. Always use the foot valve to brake.
Question 16 of 20
Pre-trip air-brake check (Step 1) is to:
Correct. In the seven-step air-brake check the first step is testing the parking brake — release service brakes, set parking brake, gently try to move the vehicle in low gear.
Question 17 of 20
You hear a steady "ssss" sound while parked with the engine off. This is most likely:
Correct. A steady hiss with the engine off indicates an air leak — find and repair before driving.
Question 18 of 20
The governor controls:
Correct. The governor cycles the compressor: it cuts the compressor in around 100 psi and cuts it out around 125 psi.
Question 19 of 20
Slack adjusters need to be checked because:
Correct. Slack adjusters control how far the pushrod must travel to apply the brake. Out-of-adjustment slack adjusters are the leading mechanical cause of out-of-service violations.
Question 20 of 20
A "wet tank" is:
Correct. The first storage tank — sometimes called the wet tank or supply tank — is where water and oil from the compressor collect. Drain it daily.
About the Alabama Air Brakes exam
States typically administer 25 Air Brakes questions and require 80% to pass. Questions cover air-brake system parts, dual systems, supply pressure, brake-system warning, slack adjusters, the parking brake, the spring brake, the pre-trip air-system check, and the proper way to perform a leakage-rate test.
The Alabama Law Enforcement Agency Driver License Division follows the federal CDL standards established by FMCSA. To earn the Air Brakes credential, you must answer at least 80% of the questions correctly. Many candidates score lower the first time because the test pulls from a large pool — refreshing this page will give you a different mix of questions, drawn from the same authoritative source.
Want more practice? Try the full Air Brakes question bank or browse all Alabama CDL practice tests.